Main Tab Settings - DAVIS TECHNOLOGIES TMS-9500-SL Short Manual

Main Tab Settings:

The Self Learning units incorporate two different
methods to control wheel spin.
The second patented method is a less advanced
process where the users sets a threshold of
acceleration that if exceeded will cause the timing to
retard.
The second- Non-Self Learning system is activated
when the "Threshold" setting is set to anything other
than zero. The Non-Self Learning Method is only
accessible using the "Traction Control Panel
Software".
Threshold is used to set this value. The higher the
number the more sensitive the system is. A good
starting point is 4. Valid settings for threshold are 1-
9.
Mode is used to adjust the Mode of the unit using the
software instead of the button on the unit as
described earlier in this manual.
Note: To use the Mode and Threshold sliders in the
software, you must check the "Set Dials Here" box.
When checked, the TC unit only uses the TCP
settings, and the setting cannot be changed using the
button on the unit. To use the button method, YOU
MUST UN-CHECK THIS BOX!
20
Davis Technologies TMS-9500-SL Short
www.moretraction.com