Page 3
UTILITIES / HOOK-UP Air Inlet: 3/8” Dia. (9mm) supply tube (Use in-line 10µ air filter). Air Supply: 20-80 psig clean dry air or nitrogen (Refer to pump operation manual for maximum temperature/pressure chart). The Mufflers on the Oscillator control Module can be removed for remote exhaust and purge connections.
Page 4
Figure 1-2 WARNING: Particulate, water and oils in the air supply can damage the oscillator. PAGE 4 PC6 OSCILLATOR OPERATION / MAINTENANCE MANUAL...
OSCILLATOR CYCLE RATE Applications with low flow or highly viscous fluid may require a slower cycle rate for increased efficiency. A slower cycle rate will also decrease air consumption. ADJUSTMENT INSTRUCTIONS Adjust timer dial to adjust cycle rate. To increase, rotate CCW •...