Advertisement
In order to maximize your listening experience please read the following instructions.
Additional large and small earbud tips included (medium tips installed on earbuds).
Prior to first use, remove the plastic battery isolator tab located between the earbuds and the charging case.
TO | DO THIS |
Power ON | Remove the earbuds from the charging case or press and hold both MFB buttons for 3 seconds. |
Power OFF | Place earbuds back in the charging case or press and hold both MFB buttons for 5 seconds. |
Play/Pause | Press either MFB button once. |
Next song | Press and hold the right MFB button. |
Previous song | Press and hold the left MFB button. |
Answer a call | Press either MFB button once. |
End a call | Press either MFB button once. |
Reject an incoming call | Press and hold either MFB button. |
NOTE: The function compatibility may vary among different smartphones or devices. Not all functions are available on all devices.
Use the included charging cable to fully charge the case before first use. It will take approximately 2 hours to fully charge.
1 LED ON indicates power level is lower than 25%.
2 LEDs ON indicates power level is between 25%~50%.
3 LEDs ON indicates power level is between 50%~75%.
4 LEDs ON indicates power level is between 75%~100%.
NOTE: To check the remaining case battery power when it is not charging, please open the case lid and take out the earbuds.
The earbuds will automatically power OFF and begin charging when they are placed in the charging case. The red LED on the earbuds will be ON to indicate the earbuds are charging and turn OFF when charging is complete.
It will take 1.5 hours to fully charge the earbuds. The earbuds can be charged 6 times using a fully charged case.
The earbuds will automatically enter Bluetooth® pairing mode when used for the first time.
If both earbuds are turned ON and paired to your device, you can return the right or left earbud to the charging case and the earbud (R or L) in your ear will continue to play. If you would like to use a single earbud for the first time, take the L or R earbud out of the charging case. Select 'HRB 5037' from your device's Bluetooth® list. To switch from using the single earbud back to TWS mode, put the L or R earbud back into the charging case, then take both earbuds out. The L and R earbuds will automatically pair to each other. Select 'HRB 5037' from your device's Bluetooth® list.
NOTE: The L and R earbuds automatically pair to each other. Should the connection fail, please follow the steps below:
If the left and right earbuds do not connect to each other, you will need to reset the earbuds and clear paired memory.
If both the left and right earbuds are paired but you are unable to connect your device via Bluetooth®, you will need to reset and clear paired memory:
To disconnect from your device while still wearing both earbuds and you are not listening to music or having a phone conversation:
Your earbuds may require periodic cleaning. Remove the tips from the earbuds and wash them with a mild detergent and water. Make sure the tips are dry before putting them back on the earbuds.
Bluetooth version: | V5.1 |
Bluetooth profiles*: | A2DP; AVRCP; HFP* |
Charging time: | 1.5 hours |
Wireless range: | 10m (32ft.) |
Playback time: | Approx. 8.5 hours** |
Standby time: | Approx. 1 day |
Rated input: | DC 5V/40mA |
Driver diameter: | 8mm |
Sensitivity: | 95dB±3dB |
Frequency response: | 20Hz-20kHz |
Impedance: | 32Ω±10% |
Battery: | Polymer Lithium |
Earbud battery capacity: | 40mAh |
IP rating: | IPX4 |
Fully powered case: | Provides up to 6 charges |
Charging time: | 2 hours |
Rated input: | DC 5V/550mA |
Output: | DC 5V/300mA |
Battery capacity: | 550mAh |
*A2DP=Advanced Audio Distribution Profile, AVRCP=Audio Video Remote Control Profile, HFP=Handsfree Profile.
**Approximate playback time, battery life depends on individual use and may be more or less than specified.
*** Bluetooth® connected, power ON, no music playing.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth® SIG, Inc. and any use of such marks by The Source (Bell) Electronics Inc. is under license. Other trademarks and trade names are those of their respective owners.
This device complies with Industry Canada license-exempt RSS standards(s). Operation is Subject to the following two conditions:
The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B)
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure users can obtain Canadian information on RF exposure and compliance.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
This device contains licence-exempt transmitters that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
CAN ICES-003(B)/NMB-003(B)
FCC ID: ZHW-8094730
The Source warrants that this product will be free from defects in materials and workmanship for a period of twelve (12) months from the date of purchase. Within this period, simply take the product and your proof of purchase to any The Source store or participating dealer and the product will be replaced (where available) without charge. Any product which has been subject to misuse or accidental damage is excluded from this warranty.
This warranty is only applicable to a product purchased through The Source company-owned stores or participating dealers in Canada where the warranty is included with the product. While this warranty does not confer any legal rights other than those set out above, you may have additional statutory rights which will vary under the laws of the various countries, states, provinces and other governmental entities in which The Source operates. This warranty is subject to all statutory rights you may have in Canada.
Imported by:
The Source, Barrie, Ontario, Canada, L4M 4W5
Manufactured in China
www.thesource.ca
© 2021 The Source. All rights reserved.
Please Recycle
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download HEADRUSH HRB 5037 - True Wireless Sport Earbuds Manual
Advertisement
Need help?
Do you have a question about the HRB 5037 and is the answer not in the manual?
Questions and answers