Advertisement
Frequency Response:
Architects' and Engineers' Specifications:
PC Boundary Satellite
The microphone shall be a freestanding, wireless, boundary
microphone, and shall produce a high degree of output
signal quality despite the possible near-field presence of
RF (Radio Frequency) devices; such as cell phones. The
microphone will have an integral 4-pin TA4F connector,
which interfaces directly to and receives power from an
Electro-Voice or Telex bodypack transmitter. The microphone
shall have four (4) selectable polar patterns: omnidirectional,
cardioid, supercardioid, and figure 8. The mic will contain
a pair of back-electret condenser elements and the mic
will have an on axis response of 50 Hz to 20 kHz. The
microphone shall have an output impedance of 1000 Ohms.
The microphone will have a switchable high pass filter
to attenuate low frequencies. The microphone shall have
an output level of 17.8 mV/Pascal, and outputs shall not
be appreciably affected by the following temperature and
humidity extremes: -29°C to 74°C (-20°F to 165°F) when the
relative humidity is 0–50%; -29°C to 57°C (-20°F to 135°F)
when the relative humidity is 0–95%. The dimensions shall
be 140.8 mm (5.5 inch) long, 81.2 mm (3.2 inch) wide, and
50.3 mm (2.0 inch) high. The microphone will have a front
mounted membrane switch to control the muting of the
microphone audio, and an LED light to indicate when the
audio is active. The operation of the membrane switch will be
configurable for push on/off, push-to-talk, and push-to-mute
operation. Furthermore, when the membrane switch is set
for push on/off, the status of the microphone audio when
power is initially applied (bodypack power turned on), can
be programmed to be either on or muted. The microphone
will allow access to the bodypack's controls and battery
without removing the bodypack from the microphone. The
Electro-Voice PC Boundary Sat microphone is specified.
Warranty:
Please refer to the Limited Warranty information found at:
www.electrovoice.com
Electro-Voice
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Bosch Communications Systems
Part Number F.01U.195.895 Rev 05
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
07/2012
Polar Response:
Dimension Drawing:
Polar Choice Part Number:
PC BOUNDARY SAT • PC Boundary Satellite, Wireless
Boundary
U.S.A. and Canada only. For customer orders, contact Customer Service at:
Other Internatonal locations. For customer orders, Contact Customer Service at:
For warranty repair or service information, contact the Service Repair department at:
For technical assistance, contact Technical Support at: 866/78AUDIO
800/392-3497 Fax: 800/955-6831
+ 49 9421-706 0 Fax: + 49 9421-706 265
+ 1 952 884-4051 Fax: + 1 952 887-9212
800/685-2606
Specifications subject to change without notice.
Advertisement
