Cisco Firepower 9300 Installation & Maintenance page 20

Remove and Replace the Power Supply Module
Warning
Warning
Step 1
To remove the power supply module, face the front of the chassis, and loosen the captive screw on the right side of the
power supply module.
Step 2 Lift up the handle of the power supply to unseat it.
Step 3
Using the handle, pull the power supply module from its slot. Place your other hand under the power supply module to
support it while you slide it out of the chassis. Install the new power supply module immediately.
Installation, Maintenance, and Upgrade
20
Statement 1090 Installation by Skilled Person
Only a skilled person should be allowed to install, replace, or service this equipment. See statement
1089 for the definition of a skilled person.
Statement 1091 Installation by an Instructed Person
Only an instructed person or skilled person should be allowed to install, replace, or service this
equipment. See statement 1089 for the definition of an instructed or skilled person.
Installation, Maintenance, and Upgrade