Smith SPS10 Setup And Operation Instructions

Hide thumbs Also See for SPS10:

SPS10 ELECTRIC SETUP AND OPERATION

ADJUST HANDLEBARS

There are 4 x 9/16" bolts. Nearly every adjustable bolt on the

machine is a 9/16".

We recommend the handle be moved to

a 45° angle toward the machine. With

the handle in that position, the operator

can put their foot on the back of the

machine to turn it.

Remove the four bolts holding the sideplate.

Remove sideplate and insert drum. When

drum is installed, replace sideplate.

PCDs, diamonds, and milling cutters are

DIRECTIONAL; they can only go forward.

Improper installation will result in severe

damage to the cutters.

The sideplate arrow indicates the direction.

Table of Contents

Do you have a question about the SPS10 and is the answer not in the manual?

Page 1 ® SPS10 ELECTRIC SETUP AND OPERATION ADJUST HANDLEBARS There are 4 x 9/16” bolts. Nearly every adjustable bolt on the machine is a 9/16”. We recommend the handle be moved to a 45° angle toward the machine. With the handle in that position, the operator can put their foot on the back of the machine to turn it.
Page 2 Machine requires a minimum 50A circuit and is 220 single-phase. If running on a generator, it must have MINIMUM 11k CONTINUOUS power, not 11k MAXIMUM. Low power could result in overheating and burning out the motor. SPS10.E5.230.1 SPS10.E7.230.1 SPS10.E7.460.3 SPS10.E7.230.3...
Page 3 OPERATING THE MACHINE (cont’d) When running the machine with a water kit, be sure to rinse ALL concrete dust off the machine (including the underside) at the end of the day. Concrete dust turns into solid concrete when dried, and can result in premature bearing failure and other issues.
Page 4 To clean the filter, use a leaf blower (not an air hose) to clean the filter. Replace filter when it can no longer be cleaned, or becomes perforated. Copyright © 2022 SMITH Surface-Prep Solutions • 2504 NW 19 Street • Pompano Beach, FL 33069 • 800-653-9311...