Page 1
™ Line Striping Systems to steer the gun arm during spray operation. For Professional use only. Model 25M712 Important Safety Instructions Read all warnings and instructions in this manual and in related manuals. Be familiar with the controls and the proper usage of the equipment.
Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these sym- bols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard sym- bols and warnings not covered in this section may appear throughout the body of this manual where applicable.
Installation Installation 3. Mount control (14) in desired location, or to control arm of seat kit 25M716. 1. Remove clamp, shock assembly and set screws. Plug threads with set screws (13). Remove gas shock while in the fully extended, uncompressed position (i.e.
Page 4
Installation 5. If necessary, adjust drive roller (6) engagement by 6. If necessary, adjust rollers to eliminate movement in loosening clamp (4) nut (1/8 to 1/4 turn) and then the traverse bracket/gun arm carriage. Loosen roller spinning the clamp counterclockwise for more nuts just enough so that when the adjustment bolt is engagement, or clockwise for less engagement.
Operation Operation 1. To power the steerable carriage, the RoadPak/ 3. Use toggle switch and speed knob together to con- RoadPak HD key must be turned to the accessory trol the direction and the speed at the same time. position, or the engine must be running. Otherwise set the desired speed, and use the toggle switch to control the direction.
Page 7
Parts List Parts List Ref. Part Description Qty. Ref. Part Description Qty. 867517 SCREW, hex head, 3/8-16 x 3.5” 17T850 BRACKET, mount, pivot 101566 NUT, lock, 3/8-16 17T851 BRACKET, motor, weldment 131391 BEARING, flanged sleeve 131377 MOTOR, gear, right angle 131423 SCREW, set.
Page 8
Original instructions. This manual contains English. MM 3A5407 Graco Headquarters: Minneapolis International Offices: Belgium, China, Japan, Korea GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA Copyright 2017, Graco Inc. All Graco manufacturing locations are registered to ISO 9001. www.graco.com...