Advertisement
6/7. Static RGB color setting
The keys in this area set the RGB static color. Press the
colored keys to set the RGB LEDs to correspond color as
shortcut. Press
and
preset library colors.
8. Brightness control
Press
key to increase RGB LED brightness and
press
key to decrease.
9. RGB dynamic effect
These keys control the RGB dynamic effects. Press
and
to select dynamic effects and press
EFFECT
key to set the running speed of the dynamic effects.
Press the
key to activate the dynamic demo
mode, the controller will play dynamic effects in loop
with repeating for 3 times for each effect.
10. Remote indicator
This indicator blinks when remote controller is
working. If the indicator flash slowly when pressing keys, it
means the remote battery is nearly empty and please
change the remote battery (CR2032 type).
Operation
11. Using the remote controller
Please pull out the battery insulate tape before using.
The RF wireless remote signal can pass through some
nonmetal barrier. For proper receiving remote signal,
please do not install the controller in closed metal parts.
2). Press
and
seconds, within 10 seconds after the receiver powered
on.
After this operation, the indicator will flash yellow
color for 3 times and the controller will be reset to
factory default, the Tuya connection and remote pairing
will all be reset.
Protection Function
The controller has full protection function against
wrong wiring, load short circuit, overload and overheat.
The controller will stop working and the indicator will
flash with red / yellow color to indicate the malfunction.
The controller will try to recover from protection status
in a short time when the working condition is good.
For protection issues, please check the situation
with different indicator information:
Red flash: Check the output cables and load, make
sure no short circuit and the load current is in rated
range. Also the load must be constant voltage type.
Yellow flash: Check the installation environment,
make sure in a rated temperature range and with good
ventilation or heat dissipation condition.
key to select color from the
and
key simultaneously for about 3
12. Setup Tuya connection
Please install the Tuya app to setup the smart
connection. Before setup, please make sure the controller
is at factory default mode and not connected to other
gateway or router. The controller indicator should be yellow
color at this status.
13. Pair a new remote controller
The remote controller and receiver is 1 to 1 paired as
factory default. It's possible to pair maximum 5 remote
controllers to one receiver and each remote controller
EFFECT
could be paired to any receivers.
To pair a new remote controller, please follow two
steps:
1). Plug off the power of receiver and plug in again
after more than 5 seconds.
2). Press
seconds, within 10 seconds after the receiver powered
on.
After this operation, the indicator will flash 3 times
to acknowledge that remote pairing is accomplished.
14. Reset to factory default
To reset the controller's Tuya setting and unpair all
remote controllers, please operate with following two
steps:
1). Plug off the power of controller and plug in again
after more than 5 seconds.
4
Specification
Model
Output Mode
Working voltage
Rated output current
Tuya connection
Remote frequency
Remote control distance
PWM grade
Overload protection
Overheat protection
Controller dimension
Remote dimension
6
and
key simultaneously for about 3
NT30(W/Z/B)
PWM constant voltage
DC 12-24V
3x4A
W: Wifi; Z: Zigbee; B: Bluetooth
433.92MHz
>15m at open area
4000 steps
Yes
Yes
87x24x15mm
86.5x36x8mm
5
Advertisement
