Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Oasis Aquatics CX Logix
Summary of Contents for Oasis Aquatics CX Logix
-
Page 2: Table Of Contents
Turning OFF the CX Logix ........................ 10 TROUBLESHOOTING ....................... 11 SPARE PART NUMBERS ......................12 WARRANTY ..........................13 TECHNICAL SUPPORT ......................14 RECORD YOUR READINGS AND NOTES HERE ..............15 CX Logix Operation MANUAL – Updated July 2022 Page 2 of 15... -
Page 3: Important Warnings & Safety Instructions
• Observe all applicable local, state, and federal safety regulations. • Take proper precautions with prescribed environmental and operational conditions. • Consider chemical compatibility with all wetted materials. CX Logix Operation MANUAL – Updated July 2022 Page 3 of 15... -
Page 4: General Overview
The pH of the water can be lowered by the addition of hydrochloric acid – and if your system has the optional pH control, this can be done automatically. The CX Logix controller uses an algorithm to calculate how much how much acid needs to be dosed to correct the pH. -
Page 5: Maintenance
Read and keep your manual in a safe place. • Test your swimming pool water on a regular basis and take your pool water sample to your local pool professional at least twice a month. CONTENTS CX Logix Operation MANUAL – Updated July 2022 Page 5 of 15... -
Page 6: Tools Needed
When pH is high you can add Hydrochloric Acid to lower the pH. When pH is low you can add sodium bicarbonate (soda ash) to increase the pH. CX Logix Operation MANUAL – Updated July 2022 Page 6 of 15... -
Page 7: Installing The Ph Controller
NOT too close to other equipment or power outlets, but close enough to the Oasis Chlorinator power supply so the piggy-back power cord can plug in to its socket outlet. Attach the CX Logix controller to the wall by removing the simple “Click ON – Click OFF” STEP 3 wall mounting bracket that is attached to the controller case. - Page 8 Start up your pool pump and check the system for any leaks. Repair any such issues. STEP 11 Prime the acid feed lines and finalise run settings using the menus below. CX Logix Operation MANUAL – Updated July 2022 Page 8 of 15...
-
Page 9: Navigating The Lcd Ph Menus On Your Sanitiser
Control Mode – Turning on the pH Mode The default setting on the chlorinator is for the acid dosing system to be ‘OFF’. This needs to be turned to ‘ON’ to operate the CX Logix. pH CONTROL MODE To turn ON the acid dosing of the pH controller, enter the ‘pH MODE’... -
Page 10: Ph2 Demand Or Prime - Add Acid Manually Or Prime Clear Flexible Pvc Tubes
[+] or [-] to change Then use the [+] or [-] button to change the selection from ON to OFF [OK] SAVE [<] EXIT and press [OK] to save. CX Logix Operation MANUAL – Updated July 2022 Page 10 of 15... -
Page 11: Troubleshooting
TROUBLESHOOTING If you suspect for any reason your Oasis CX Logix Controller is not performing or running as it should be, here are some handy troubleshooting tips that may assist you. Fault Indication Potential Cause Remedy pH control mode has not been See Manual Section 10.1... -
Page 12: Spare Part Numbers
PCB - pH LOGIX Main PCB N01364 Power Cord - pH c/w Piggyback Socket N01367 pH Non-Return Injector Valve c/w Sleeve & Tube Nut N01368 pH Suction Valve c/w Tube Nut CX Logix Operation MANUAL – Updated July 2022 Page 12 of 15... -
Page 13: Warranty
Oasis Aquatics other than what is stated here. This limited warranty is the sole and complete warranty for Oasis Aquatics and shall be limited to the cost of the meter. -
Page 14: Technical Support
No liability or responsibility is accepted for any loss suffered as a result of any user’s reliance on such content. CX Logix Operation MANUAL – Updated July 2022 Page 14 of 15... -
Page 15: Record Your Readings And Notes Here
RECORD YOUR READINGS AND NOTES HERE CX Logix Operation MANUAL – Updated July 2022 Page 15 of 15... - Page 16 Unit 4, 8 Reichert Drive Knoxfield VIC 3180 Seven Hills NSW 2147 Molendinar QLD 4214 Australia Australia Australia T: 03 9887 2131 T: 02 9838 0000 T: 07 5679 6821 oasisaquatics.com.au info@oasisaquatics.com.au CX Logix Operation MANUAL – Updated July 2022 Page 16 of 15...
Need help?
Do you have a question about the CX Logix and is the answer not in the manual?
Questions and answers