Page 1
Models: P1SRR-08S, P2SRR-16S, P3SRR-24S Refrigerated Sandwich Prep Units Models: S1BRR-06S, S2BRR-12S, SD3BRR-18S, M1P-2712, M2P-4818, M3P-7127 Undercounter Refrigerators & Freezers Models: U1BRR-06S, U1BFF-06S, U2BRR-12S, U2BFF-12S ColdTech This manual contains important information regarding your new unit. Please read the manual thoroughly prior to equipment set-up, operation and maintenance.
Page 2
LIMITED WARRANTY Jimex Corp. warrants to the original purchaser the ColdTech unit sold and all parts thereof to be free from defects in material or workmanship, under normal use and service for a period of one (1) year from the date of purchase.
Page 3
IMPORTANT!!! PLEASE READ BEFORE INSTALLATION 1) If the unit has recently been transported please let unit stand still for a minimum of 24 hours before plugging it in. 2) Make sure that the unit drops down to desired temperature before loading the unit with product. 3) Make sure that there is proper ventilation around the unit in the area where it will operate.
DEFROST SYSTEMS Refrigerator coils are kept below the freezing point (32 F). During compressor down-time, the evaporator fan continues to circulate air through the evaporator coil. This air circulation raises the coil temperature above the freezing point, melting any accumulated frost. Run-off water is drained into the evaporator pan and evaporated.
Page 5
Please pay close attention the the safety notices in this section. Disregarding these notices may lead to serious injury and/or damage to the unit. ATTENTION UNPLUG CORD 1) To minimize shock and fire hazards, be sure not to overload outlet. Please designate one outlet for your unit.
For efficient operation, it is important that the condenser surface be kept free of dust, dirt, and lint. ColdTech recommends cleaning the condenser coil and fins at least once per month. Clean with a commercial condenser coil cleaner, available from any kitchen equipment retailer. Brush the condenser fins from top to bottom, not side to side.
Page 7
SYMPTOM Compressor not running. Condensing unit runs for long periods of time. Cabinet temperature is too warm. Cabinet is noisy. POSSIBLE CAUSE Fuse blown or circuit breaker tripped. Power cord unplugged. Thermostat set too high. Cabinet in defrost cycle. Excessive amount of warm product placed in cabinet.
Page 8
Please read the entire manual carefully before installation and operation. If certain recommended procedures are not followed, warranty claims will be denied. Notice: ColdTech reserves the right to make changes in design and specifications without prior notice. MODEL #: _______________________________...
This manual is also suitable for:
U2bff-12sU1brr-06sU2brr-12sP1srr-08sP2srr-16sP3srr-24s...
Show all