Mounting With Screws; Mounting With Adhesive Strip - Power Tech Generators POWERTECHCS Manual

Wireless Sensor Installation

Mounting with Screws:

If your surfaces are rough, dirty or prone to
high heat or humidity, install your wireless
sensor with the supplied bracket and screws.
• Remove the wireless sensor from its supplied
mounting bracket to expose the screw holes.
• Align the mounting bracket in the desired
location. Be sure to drill a pilot hole to avoid
any cracking or chipping on the surface.
• Secure the mounting bracket using the
supplied mounting screws.
• Snap the wireless sensor into the
mounting bracket.
6
Wireless Sensor Installation

Mounting with Adhesive Strip:

• Make sure the surface is clean and dry.
• Peel the protective cover off the adhesive
strip on the back of the mounting bracket.
• Align the mounting bracket in the desired
position and press evenly with your palm.
Hold in place for at least 30 seconds.
•
• Plug the wireless sensor into the wireless
module and tighten the two hex screws.
• Snap the wireless sensor into the
mounting bracket.
7