Download Print this page
Silent Gliss 9060 User Information

Silent Gliss 9060 User Information

System 5600

Advertisement

Quick Links

User Information
Silent Gliss 9060 Motor – System 5600

Advertisement

loading
Need help?

Need help?

Do you have a question about the 9060 and is the answer not in the manual?

Questions and answers

Summary of Contents for Silent Gliss 9060

  • Page 1 User Information Silent Gliss 9060 Motor – System 5600...
  • Page 2 Specifications Motor 0°C … + 60°C Operating temperature Unrestricted operation of rated data -20°C … + 70°C range Storage Protection class IP40 Operation in dry rooms 100 … 250 VAC / 50 … 60 Hz Nominal voltage Max. Current 0.5 A @ 240V, 1.3 Amp @ 110V Max.
  • Page 3 DIP-Switch settings DIP- Operation mode Switch- Position 1 – X – X latching 0 – X – X non latching X – 1 – X Touch & Go and Manual Override on X – 0 – X Touch & Go and Manual Override off X –...
  • Page 4: Limit Setting

    Limit Setting If the 5600 you have ordered has been supplied in a single piece the end limits will already be set, here if you need to adjust the limits follow the manual end stop programming instructions. If the 5600 you have received has been supplied in two or more parts then the limits must be set.
  • Page 5 Overview of Connection and Control Elements on the 9060 motor (View of the bottom of the motor) (Green Button) (Green) (Yellow) (White Button) Use White programming button M (manual) on overview above for manual limit setting Use green programming button A (automatic) on overview above for automatic...
  • Page 6 1. Manual Limit setting (White M button) Plug in power lead Press white button for 1 second Using 0997 setting lead (The yellow LED will light when a direction button is pressed). 1. Push and hold button in the first direction until desired end position is reached –...
  • Page 7 2. Push and hold button for the opposite direction until the second end position is reached- then release. 3. Now push button in first direction and hold until the movement stops automatically – then release. The yellow LED will now go out. The motor is now ready for use.
  • Page 8 2. Automatic limit setting (green A button) 10725 used to enlarge the stack Permanent Press green button for 1 second, the Power green LED will flash The motor will now set the end limits automatically – each limit set in sequence. The motor is ready for use Remove when the green LED stops...
  • Page 9: Radio Control

    The System is now ready for use if being switched from an external switch If the motor has been supplied with a radio receiver this can now be assigned to the handset provided – refer to the 9060 manual supplied. Radio Control Addressing 9940 Radio Control Programming the transmitter –...
  • Page 10 Addressing 0450 Radio Control Programming transmitters - Quick guide Requirement The motor is installed on the track and permanent power as per wiring diagram E303. Stand in front of the motor to be programmed for the addressing. A) Single Channel Wall Plate or Handset (refer to user manual for full instructions) Step 1.
  • Page 11 Step 4. LED flashes to confirm address signal sent Press and hold both button for 5 seconds Handset is now addressed B) 8 Channel Wall plate (refer to user manual for full instructions) Step 1. Set address on DIL switches in controller Step 2.
  • Page 12 Step 3. When the magnet is placed in the correct position you will hear a continuous tone – leave in place for 10 seconds until the tone pulses – remove magnet. The receiver is now in programming mode for approx 5 minutes. Step 4.