Unit Setup - pureHeat Table Owner's Manual

UNIT SETUP

Use the Setup Diagram (Page 7) for a visual representation of the assembly instructions.
INSPECT THE UNIT FOR DAMAGES BEFORE SETUP OR USE.
1 . Remove the Main Body, Base, Base Cover, and assembly pieces from the packaging.
2 . Stand the Main Body on its top.
3 . Place the Base Spacers over the Base Brackets .
4 . Place the Base Plate Cover over the Base Plate, then slide them over the Base Brackets,
orienting the Power Cord Port on your preferred side.
5 . Pull your Power Cord through the main hole in the Base Plate Assembly.
6 . Place the Base Washers in the Two (2) locations on the bottom of the Base Plate and fasten
with the (2) M6*20 Screws.
7 . Lay the Power Cord over the edge of the Base where the Power Cord Port is located. Fasten
the Power Cord Plate over the Power Cord with the (2) M4*35 Screws.
8 . Stand the Unit on its base.
9 . Fasten the (3) L Brackets to the Tempered Glass with the edges in. Use the (3) M8*6 &
(3) M4*6 Screws to lock them in place.
10 . Slide the Tempered Glass Top into the slots on the top of the main body and fasten them in
place with the (3) M6*16 Screws.
11 . Plug your unit in and follow the instructions for proper use.
FOR YOUR SAFETY, READ ALL WARNINGS & CAUTIONS (PAGE 5) AND USAGE (PAGE 8) BEFORE
USING YOUR PUREHEAT TABLE.
6