Shutting Off Engine - Simpson PowerShot Pro Series Use And Care Manual

NOTE: The starting position of the choke will vary depending on the engine temperature. If
starting a cold engine, move the choke lever towards the CHOKE position. If starting a warm
engine, move the choke lever towards the RUN position.
6. Pull the recoil slowly until resistance is felt, then pull rapidly to start the engine.
Rapid retraction (also known as kickback) of the engine recoil starter cord will pull your
hand and arm towards the engine faster than you can let go of the handle resulting in
sprains, broken bones, lacerations, and/or traumatic amputations. Kickback is caused
by damage to the engine crankshaft key, compression release failure, and/or improper
starting techniques. To avoid kickback follow the appropriate maintenance schedule,
starting instructions and have repair work done by an authorized service center.
7. Once the engine starts, slowly move the choke lever to RUN as the engine runs. If
the engine falters, move the choke toward CHOKE until the engine has warmed up.
Turning off the water supply to your pump with the engine running will damage the pump.
Damage caused by running the pump without water is not covered under warranty. To
avoid this hazard always turn off the engine before shutting off the water supply.
1. Slide the throttle to the SLOW position (if equipped).
2. Turn the engine switch to the OFF position.
3. Slide the fuel valve to the OFF position.
4. Turn off the water supply.
5. Squeeze the spray gun trigger to relieve the pressure in the hose and pump.
6. Allow the engine to cool completely before handling and storage.
Page 21
WARNING: WARNING:

SHUTTING OFF ENGINE

NOTICE
RAPID RETRACTION
CHOKE
RUN
PUMP DAMAGE