ATEN VanCryst VE2812R - DMI HDBaseT Receiver Quick Start

Package Contents

1 VE2812R HDMI HDBaseT Receiver with Audio De-Embedding

1 RS-232 Terminal Block

4 Foot Pads

1 Power Adapter

1 User Instructions

Hardware Review

Front View

1. Audio Out (Coaxial)
2. Audio Out (Stereo)
3. Audio Channel Switch
4. IR Port
5. HDMI Audio Out Switch
6. HDMI Video Out

Top View

1. HDMI Out LED
2. Link LED
3. Power LED

Rear View

1. HDBaseT In
2. RS-232 Serial Port
3. RS-232 Serial Communication Switch
4. Long Reach Mode Switch
5. Firmware Upgrade Switch
6. Power Jack

Hardware Installation

To install the VE2812R, refer to the installation diagram above and follow the steps below:

1. Connect an HDMI-enabled display to the VE2812R's HDMI Out port.
2. Follow the steps below to set up your audio output.
   1. To use an independent speaker, connect the speaker to the VE2812R's Audio Out port (coaxial or stereo) using an appropriate audio cable.
   2. Depending on the interface of your chosen audio output device, adjust the Audio Channel Switch.

Note: Stereo audio will be mute if the channel is set to Ch5.1.

3. To mute the audio on the connected HDMI display, put the HDMI Audio Switch to OFF.

6. Ground the devices connected to the VE2812R to prevent damages from power surges or static electricity.
7. Plug the power cord into the VE2812R's power jack.

Long Reach Mode
To extend the VE2812R's 4K signals up to 150 m, put the Long Reach Mode Switch to ON.

Support and Documentation Notice

All information, documentation, fi rmware, software utilities, and specifi cations contained in this package are subject to change without prior notifi cation by the manufacturer.

To reduce the environmental impact of our products, ATEN documentation and software can be found online at http://www.aten.com/download/

Technical Support
www.aten.com/support

Scan for more information

EMC Information
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

FCC Caution: Any changes or modifi cations not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

Operation of this equipment in a residential environment could cause radio interference.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

© Copyright 2019 ATEN^® International Co., Ltd.

ATEN and the ATEN logo are trademarks of ATEN International Co., Ltd. All rights reserved. All other trademarks are the property of their respective owners.

Part No. PAPE-1223-Q40G Printing Date: 03/2019