Table of Contents
Advertisement
Parameter Group P02.xx
Display
Parameter No.
Meaning of Parameter
Setting Range of Parameter
P02.00
Fix value 0
P02.01
Display updating sequence
Range: 0.1 .. 9.9
Parameter Group P03.xx
Analog Output
Parameter No.
Meaning of Parameter
Setting Range of Parameter
P03.00
High end of analog output
at speed
Range: 00001 .. 99999
P03.01
Low end of analog output
at speed
Range: 00001 .. 99999
P03.02
Live Zero
Range: 0 .. 1
P03.03
Fix value 1
P03.04
Forced output level at
sensor fault condition
Range: 0 .. 2
P03.05
Output direction
Range: 0 .. 1
Description of Parameters and their Settings
Independent from the response time used for other functions, the display
may have its own up-dating sequence - again in the interest of stabilized and
well legible readings. Set the time between updates in steps of 0.1 sec.
A recommended value is 0.3 sec.
Description of Parameters and their Settings
The high end defines at which speed (RPM) the output delivers 20 mamps.
The low end defines at which speed (RPM) the output delivers
0 resp. 4 mamps.
The analog signal can be without or with live zero.
Setting:
0 : " without live zero" = 0...20 mA
1 : "with live zero"
Setting:
0 : no,
output follows measured speed
1 : min:
output goes to < 0 mamps
2 : max:
output goes to approx. 21 mamps
Setting:
0 : normal
(0/4. .20 mA with increasing speed)
1 : inverted
(20...0/4 mA with increasing speed)
E16521D-Manual_EN_Rev12
= 4...20 mA
2021_JAN_14
Page 15 of 26
Advertisement
Table of Contents
