Table of Contents
Advertisement
1. The unit may be mounted either between joists using the inbuilt clip fasteners or
against a joist using a screw through the flange plate.
2. The approximate cut-out size of the 2 Lamp unit is 355 x 200 mm.
3. The approximate cut-out size of the 4 Lamp unit is 310 x 300 mm.
Please note this is only an approximate measurement and any installation would
require a measurement against the physical product to ensure the best fit.
4. Mark the ceiling with a pencil showing the area of ceiling to be cut.
IMPORTANT NOTE: Goldair takes no responsibility for those instances where the physical
product is not measured first before the hole is cut in the ceiling.
5. Before commencing cutting ensure that the area behind the intended location is
clear of all cables, pipes and joists. Once clear, cut out the section along the
previously marked lines.
6. Remove the lamps from the housing by unscrewing them anticlockwise. Then
remove the decorative fascia from the housing by removing the spring clips that hold
it in place.
7. Insert the unit into the hole being sure to pull the side springs inward so that the
body can pass through the hole without damaging the plaster. Ensure that the unit is
held securely in place by clips. It is essential that additional screws (not supplied) are
used to aid holding the unit in the ceiling. Screw holes are provided in the flange for
this purpose. 2 strips of timber (one on each side) should be placed behind the holes
inside the ceiling to give the screws something to anchor to and to provide some
reinforcing. Do not secure the unit at this time.
8. Remove the unit from the ceiling and connect the wiring to the terminal block as per
the wiring diagram. This terminal block is on one corner of the back of the unit.
9. Attach ducting to extract the air to the outer wall using flexible ducting, clamps and
vent outlet grille provided. Fix and tighten the clamps firmly to hold the flexible duct
to the unit and the outer wall vent.
10. Insert the unit into the hole and secure as detailed in point 4 above.
11. Hold the fascia against the body of the appliance and the ceiling, then attach the
securing spring clips to hold the fascia in place.
12. Now screw in the heat lamps provided into the lamp holder through the holes
provided in the fascia. The globes should be screwed in firmly to ensure a good
electrical contact but don't over tighten. Fit the small centre light bulb in the same
way ensuring that it is positioned centrally.
13. IMPORTANT NOTE: Over tightening of heat lamps or light bulbs may result in
damages to the lamp holders or lamps, take care when removing and replacing heat
lamps/bulbs.
Installation Instructions
Advertisement
Table of Contents
