Page 3
Information relevant only for the EX area is marked with General Safety The RZ-24 central is a power supply with integrated tripping device for hold-open systems on fire doors, smoke evacuation flaps etc. Instructions The RZ-24 is also the central of the DICTATOR hold-open system in hazardous areas.
Page 6
- RM 3000IS EX smoke detector or WM 3000IS EX heat detector with base, part no. 040881SET or 040886SET - Resistor 3.9 kΩ (included in the scope of delivery of the RZ-24 central) - Explosion-proof magnet (DICTATOR electromagnets EM GD 50 EX or...
Page 7
- RM 4000 smoke detector or WM 4000 heat detector with base, part no. 040860SET or 040861SET - Resistor 3.9 kΩ (included in the scope of delivery of the RZ-24 central) - Magnet (DICTATOR electromagnets EM GD 50 to EM GD 70 - see separate catalogue pages) - Hand release switch, part no.
Installation etc. also in hazardous areas. When using the RZ-24, it is mandatory to respect in addition to the re- gulations for hazardous areas also the regulations of the general type approval Z-6.500-2443. The RZ-24 central itself is not ex-proof and therefore must be moun- ted outside the hazardous area.
IP rating IP 64 when IP 64 cable inlets are used IMPORTANT: In total the RZ-24 central provides 0.9 A for the supply of the connected fire detectors, magnets etc. In case the maximum power consumption is exceeded, the RZ-24 will automatically switch off.
Page 13
Zener barrier is placed between it and the for Opening hazardous area. IMPORTANT: In case of an alarm the RZ-24 will completely electrically isolate the control system of the door operator! Safe area 230 VAC...
RZ-24 Central 7. Placing into Operation of the Hold-Open System 7a) Steps for Placing into - After having connected all components in the RZ-24 central, close the cover and secure it with the 4 screws. Operation - Switch on the voltage supply.
Ill. 12 key "horn" (4). 8b) Deactivating the The integrated horn of the RZ-24 can be deactivated, when you don't want the tripping of a detector to be signalled acoustically. For this pur- Integrated Horn pose simply remove the jumper (5) (DON'T throw it away, but fix it with adhesive tape to the inside of the cover for a possible later activation!).
Need help?
Do you have a question about the RZ-24 and is the answer not in the manual?
Questions and answers