adairs HR ARLO DINING CHAIR Assembly Instructions

A S S E M B L Y I N S T R U C T I O NS

Remove all wrapping material, staples and packing straps from the carton.

See Hardware and Parts List & check you have all parts before you start assembling.

Place all furniture parts on a clean and flat soft surface, such as carpet or rug to prevent the item from being scratched.

FOR ASSEMBLY

There are 2 x Screw Lengths that must be used in correct holes (screws A & B).

Please check instructions carefully A & B screw lengths are different.

Step 1: On a soft surface, place the seat pad upside down so that you can easily see the

pre-drilled screw holes

Step 2: Place the legs in position and use the allen key provided to tighten

screws A & B to base

1 . S E A T P A D : 1 PC

2 . L E G B R A C K E T : 1 PC

Please read below instructions carefully.

A . S C R E W M 6 x 2 0 m m : 2 PC

B . S C R E W M 6 x 2 5 m m : 2 PC

C . A L L E N K E Y : 1 PC

P a g e 1 o f 2

Table of Contents

Do you have a question about the HR ARLO DINING CHAIR and is the answer not in the manual?

Page 1 A S S E M B L Y I N S T R U C T I O NS Please read below instructions carefully. Remove all wrapping material, staples and packing straps from the carton. See Hardware and Parts List & check you have all parts before you start assembling. Place all furniture parts on a clean and flat soft surface, such as carpet or rug to prevent the item from being scratched.
Page 2 A S S E M B LY I N S T R U C T I O NS ① ② ADJUST FEET WHERE REQUIRED TO ENSURE CHAIR SEATS EVENLY ON FLOOR P a g e 2 o f 2...