Advertisement
Available languages
Available languages
EN
Measure:
Press measure button detector automatic calibration in 2 sec, if calibration success, Buzzer short ring three times or long
beep one time LCD show full strength. Release the button to be re-calibrated measurements. Into the state of under test after
successful calibrated close to the material the indicate is stronger when reach the max strength BEEP long ring in AC mode the
strength above zero show the AC icon at same time Release the measure button to stop detect
Low battery detection
Voltage of battery lower than 7.0V±0.4v, LCD show low battery icon.
Warning
1. If not use battery more than 3 months please keep it in a dark and cool place, in case leakage damages the instrument.
2.If the leakage runs, should use a soft cloth to wipe out the liquid to avoid to contact skin.
3. Don't litter the useless battery, please protect environment against pollution.
4. Don't use the instrument to detect AC wire without insulation.
1. Lcd Screen
2.Left selection button
3. On/Off
4. Measure
5. Right Selection button
6. Battery Case
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior
notice unless these changes significantly affect the performance and safety of the products. The parts described / illustrated
in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line
with similar features and may not be included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty
will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement
work, including maintenance and special adjustments, must only be carried out by technicians of the authorized service
department of the manufacturer.
3
WWW.BORMANNTOOLS.COM
Technical Data
Max. Detection Depth: 50mm
Advertisement
