Advertisement
Available languages
Available languages
EN
Caution! Please read this Instruction manual carefully before using the BDM5000 four in one detector.
1. Function description and Technical Data:
LCD screen, 5 class detection indicator.
Four buttons: ON/OFF, MODE+, MODE-, MEASURE.
Low battery detection.
Automatic shut-down.
Automatic zero calibration.
Operating current<10mA, Shut-down current<10uA.
Wooden/Beam (STUD): detect depth≥19 mm, cross-sectional area of wood rafters 40mmx40mm.
METAL: detect copper pipe φ16x1 depth≥19mm, detect iron pipeφ19x1depth≥38mm,
DEEP: detect depth≥38 mm cross-sectional area of wood rafters 40mmx40mm
Electric wire (AC): detect depth is 50 mm, AC 220V 50Hz
2. LCD:
3. Buttons
ON/OFF : ON/OFF
Mode conversion (left select)
▶
Mode conversion (right select)
Measure:
4. Operation:
ON: Press ON/OFF button open the machine, LCD will show STUD METAL DEEP AC, arrow point STUD.
OFF: Two ways
Press ON/OFF
Without any operate in one min.
Mode Conversion:
Press
mode conversion (left select) or
▶
mode conversion (right select), mode switching order STUD->METAL->DEEP->AC, If present mode is AC press
effect press
mode conversion (left select), mode switching order AC -> DEEP -> METAL - >STUD, If present mode is STUD
press
no effect.
2
▶
mode conversion (right select) down arrow at the appropriate mode, press
WWW.BORMANNTOOLS.COM
▶
no
Advertisement
