Page of 2

Motorola iDEN i50sx Replacement Instructions

Faceplates and keypads removal and replacement procedure.
Hide thumbs
   
Your i50sx phone comes with a standard faceplate and keypad. You can order
additional face plates and keypads to change the look of your phone.
The following steps and accompanying illustration detail the procedure for
removing and replacing the changeable faceplate and keypad.
NOTE: Before replacing the faceplate, ensure that the audio seal and
keypad are present and undamaged. For security and
operational reasons, power to the i50sx phone should be off
prior to performing the removal and replacement procedure.
There is a protective plastic liner over the lens. Peel off prior to
operation.
Removal and Replacement Procedure
1
While holding the back of the phone, press the faceplate release button
located at the bottom of the phone to release the faceplate.
2
In an upward motion, grasp the bottom part of the faceplate and detach
it from the phone, while also detaching the upper part of the faceplate
from the phone.
3
Remove the keypad from the phone (or from the faceplate).
4
To replace the faceplate and keypad, lay the keypad on the phone body.
5
As shown in the illustration, attach the faceplate to the phone body, first
at the top and then at the bottom. Rotate faceplate towards bottom of the
phone until the lower snap is engaged. Snap engagement will be
verified by a click sound. After the lower snap is engaged, verify that
the upper snap is engaged by pressing the earpiece area.
6
Re-apply power to the phone by pressing the power button located on
the top of the phone.

   Also See for Motorola iDEN i50sx

   Related Manuals for Motorola iDEN i50sx

   Summary of Contents for Motorola iDEN i50sx

  • Page 1: I50sx Faceplates And Keypads

    i50sx Faceplates and Keypads Your i50sx phone comes with a standard faceplate and keypad. You can order additional face plates and keypads to change the look of your phone. The following steps and accompanying illustration detail the procedure for removing and replacing the changeable faceplate and keypad. NOTE: Before replacing the faceplate, ensure that the audio seal and keypad are present and undamaged.

  • Page 2

    Faceplate Phone Body Keypad Faceplate Release Button...

Comments to this Manuals

Symbols: 0
Latest comments: