Table of Contents
Advertisement
Most cleaning can be done with the drawer in
place; however, the drawer may be removed if
further cleaning is needed. Use warm water to
thoroughly clean.
1
Fully open the drawer.
2
Unscrew the screw
of the drawer.
3
Locate the glide lever on each side of the
drawer. Push down on the left glide lever and
pull up on the right glide lever.
Lever
a
Push down with finger
b
Pull up with finger
c
4
Pull the drawer away from the range.
Assembling Drawers
1
Pull the bearing glides to the front of the
chassis glide.
2
Align the glide on each side of the drawer with
the glide slots on the range.
3
Push the drawer into the range until levers
click (approximately 2 inches).
4
Insert and tighten the screws on the side at
the back of the drawer.
on the side at the back
a
5
Pull the drawer open again to seat the
bearing glides into position.
Removing/Assembling the Vent
Trim
Removing the Vent Trim
1
Using a screwdriver, remove the 3 screws
holding the vent trim in place.
2
Lift the vent trim.
Assembling the Vent Trim
Assemble the vent trim in the reverse sequence of
its removal.
Periodic Maintenance
Changing the Oven Light
The oven light is a standard 40-watt appliance
halogen lamp. It turns on when the oven door is
open. When the oven door is closed, press Light to
turn it on or off.
WARNING
• Make sure that the oven and lamp are cool.
MAINTENANCE
65
Advertisement
Table of Contents
