Advertisement
Connect base bracket (F), bottom poles (D) and base stand (E)
1
as shown using long bolts (G, J) Nuts (K) and Washers (L).
Do not tighten bolts until rack is fully assembled and tubes are
properly aligned. Fully assemble base before continuing.
Front side of rack features the
longer section of the base foot
Slide wheel tray (H) onto
3
top pole (one on each
side) making sure that
the at side of the tray
is above the wheel stop
on the frame base.
(FIGURE 1)
Tighten all bolts, using
5
the wrench to hold nuts
where needed.
O Rings (M) can be used
to slide over base legs
where needed on uneven
oor surfaces. (FIGURE 2)
FIGURE 2
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
© Copyright 2022
2
4
FIGURE 1
6
Adjust position of arms before
placing bike on stand.
Service:
for immediate response email
service@designbydelta.com
Connect center poles (C) to bottom poles (D), and
then top poles (B)- secure with short bolts (I).
Connect top
connector (A) to top
poles (B) using
long bolts (G) Nuts (K)
and Washers (L).
After rack is assembled,
wheel trays should be placed at
desired height and secured with
quick release lever. (Figure 3)
G A
G B
FIGURE 3
Please do not return to store;
Advertisement
