Advertisement
Quick Links
Advertisement
Related Manuals for Think Fencing Bellbrae Fencing
Summary of Contents for Think Fencing Bellbrae Fencing
- Page 1 Bellbrae Fencing Semi Privacy Screening. Installation Guide Bellbrae | Installation Guide...
- Page 2 Bellbrae Fence – Woodgrain Pine and Beech Bellbrae | Installation Guide...
- Page 3 Contents Getting Started Installation Tips Shortening a Panel Tools Required Instructions Bellbrae | Installation Guide...
-
Page 4: Getting Started
Do not use rapid set concrete. It will continue of the slot by rasping it out on site or have Think Fencing to absorb moisture, expanding inside posts and voiding provide custom routed posts. the warranty. Think Fencing recommends using premixed 25mpa/10mm aggregate. -
Page 5: Tools Required
Tools Required. What you will need to get the job done. Shovel Tape Measure Rasp Pre Mix Concrete Line Marking Paint String Line *not rapid set Spirit Level Silicon Gun/ Safety Glasses Rubber Mallet Crimper Angle Grinder/ Clear PVC glue Drop Saw Drill or Impact Driver 4mm Drill Bit... - Page 6 What you will need: Please Note: Think Fencing recommends checking with location services or contacting dial before you dig to make sure it is safe to dig.
- Page 7 650mm deep. The post needs to go into the concrete 600mm deep leaving a 50mm solid concrete foundation. Please note: If you have sandy/loose soil, Think Fencing recommends that you increase your hole size and amount of concrete to create a bigger foundation. What you will need:...
- Page 8 2390mm 2263mm Ground Ground Ground Concrete the next post. Its easier to accurately measure the post spacing from the inside edge of two posts rather than the centres. This measurement is the centre to centre post spacing that you used to mark the holes (as specified) minus the thickness of one post.
- Page 9 Please note: The rails will have side to side movement if the crimping marks are too far apart. To combat this you can add screws to the back of your posts hold the rails in place. Post 1 Post 2 After the post concrete has set slide the top and bottom rails into the pre-routed slots.
- Page 10 Back-brace Notched out for Top Rail Section to screw into pickets Notched out for Bottom Rail On the inside of the property, align the back-brace in the centre of the fence between posts. Fix to top and bottom rail What you will need: with 40mm screws provided.
- Page 11 Finish by placing the post caps on using clear silicone or clear PVC pipe glue. Please note: be careful if applying glue, spread evenly inside the cap so no glue runs down the fence post. What you will need: Bellbrae | Installation Guide...
- Page 12 Head Office: 2415 Geelong/Portarlington Road, Portarlington, 3223 Victoria Australia P. +613 5259 2555 E. sales@thinkfencing.com.au www.thinkfencing.com.au Bellbrae | Installation Guide...
Need help?
Do you have a question about the Bellbrae Fencing and is the answer not in the manual?
Questions and answers