Table of Contents
Advertisement
Installation & Service Manual
CLEANING AND SANITATION
Component Removal and
Installation Instructions for
Cleaning
Shelves and Shelf Brackets
1. Open the front curved glass by lifting the
handle at the bottom.
2. Remove product from shelves.
3. Unplug light cord from socket in mullion
covers. Completely insert socket cover in
the light socket to protect the receptacle.
4. Remove shelves and shelf brackets from
slots in rear uprights.
5. After cleaning, replace in reverse order.
Bottom Trays
1. Open the front curved glass by lifting the
handle at the bottom.
2. Remove product from bottom of case.
3. Grasp and lift out each of the bottom trays
from the case interior.
4. After cleaning, replace in reverse order.
Front Air Ducts
1. Remove bottom trays, see this page.
2. Lift out front air duct sections.
3. After cleaning, replace in reverse order.
Mullion Covers
1. Open the front curved glass by lifting the
handle at the bottom.
2. Remove mounting screws from each
mullion cover.
November, 2005
NLBR, NLBN, NLBS
WARNING
Mullion covers with electrical receptacles
can be cleaned without removing the
electrical receptacles. Do not get moisture
on electrical wires when cleaning under
this cover. Moisture on wires could cause
premature product failure and/or personal
injury or death from electrical shock.
3. Carefully remove each mullion cover from
the rear uprights.
4. After cleaning, replace and secure mullion
covers in reverse order.
Front Lower Cladding
1. Remove front kickplate.
2. Lift and pull out front lower cladding until
rear tabs clear holes in front of frame
assembly. After rear tabs are clear, pull
down on cladding to clear upper tabs
from slots in bottom of upper front
cladding and remove cladding from case.
3. After cleaning, replace front lower
cladding by inserting top tabs, then rear
tabs. Make sure all tabs are securely fit
in each slot. Replace front kickplate.
Front Upper Cladding
1. Remove color band, bumper and bumper
retainer from the case. See page 19.
2. Remove front kickplate and front lower
cladding. See above.
3. Remove screws from top and bottom of
front upper cladding and remove front
upper cladding.
4. After cleaning, replace front upper
cladding and remaining front components
in the reverse order.
Page 15
Advertisement
Table of Contents
