Advertisement
Available languages
Available languages
area where power tool will move
if kickback occurs. Kickback will
propel the tool in direction opposite
to the wheel's movement at the point
of snagging.
d) Use special care when working
corners, sharp edges etc. Avoid
bouncing
and
accessory. Corners, sharp edges or
bouncing have a tendency to snag
the rotating accessory and cause
loss of control or kickback.
e) Do not attach a saw chain
woodcarving blade or toothed
saw blade. Such blades create
frequent kickback and loss of
control.
Safety
Warnings
for
Grinding
Operations:
a) Use only wheel types that are
recommended for your power tool
and the specific guard designed
for the selected wheel. Wheels
for which the power tool was not
designed cannot be adequately
guarded and are unsafe.
b) The grinding surface of centre
depressed
wheels
mounted below the plane of the
guard lip. An improperly mounted
wheel that projects through the
plane of the guard lip cannot be
adequately protected.
c) The guard must be securely
snagging
the
Specific
and
cutting-off
must
attached to the power tool and
positioned for maximum safety,
so the least amount of wheel is
exposed towards the operator.
The guard helps to protect operator
from broken wheel fragments and
accidental contact with wheel and
sparks that could ignite clothing.
d) Wheels must be used only for
recommended applications. For
example: do not grind with the
side of cut-off wheel. Abrasive
cut-off wheels are intended for
peripheral grinding, side forces
applied to these wheels may cause
them to shatter.
e) Always use undamaged wheel
flanges that are of correct size and
shape for your selected wheel.
Proper wheel flanges support the
wheel thus reducing the possibility
of wheel breakage. Flanges for cut-
off wheels may be different from
grinding wheel flanges.
f) Do not use worn down wheels
from larger power tools. Wheel
intended for larger power tool is not
suitable for the higher speed of a
smaller tool and may burst.
be
3. Specific Safety Rules
- Check that speed marked on the
wheel is equal to or greater than the
rated speed of the grinder.
- Ensure that the wheel dimensions
are compatible with the grinder.
7
Advertisement
