Advertisement
Available languages
Available languages
Cutting-off operation
When equipped with cutting-off
wheel and guard, hold the grinder
at 90° to the work piece for the best
work results.
Guide back and forth over the work
piece in a steady motion.
Overload
The motor of your right angle
grinding machine may be damaged
when
overloaded.
from excessive working pressure
over a prolonged period. Therefore
you should not try to accelerate
your working speed by increasing
pressure on your machine. The
abrasive disks work more efficiently
if only slight pressure is exerted on
the grinding machine, thus avoiding
a drop in the grinding speed.
7. Maintenance / Cleaning
Always be sure that the tool is
switched off and unplugged before
attempting to perform inspection or
maintenance.
This
results
If the carbon brushes need to be
replaced, have this done by a qualified
repair person (always replace the two
brushes at the same time)
If the supply cable is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
The tool and its air vents have to be
kept clean. Regularly clean the tool's
air vents or whenever the vents start
to become obstructed.
8. Storage
Store the angle grinder in a dry
place. Regularly inspect the disks
/ wheels, ensure that the disks /
wheels is free of cracks and surface
defects. Replace the disks / wheels
when it has wore out.
Take care not to expose this tool to
the rain.
9. Check the delivery parts
Carefully remove the tool from its
packaging and check if the following
parts are complete:
1 x Angle grinder
1 x Side handle
1 x cutting-off protective cover
1 x grinding protective cover
1 x spanner
12
Advertisement
