Overview Of Water Hardness Set- Tings; Setting The Water Softening Sys- Tem; Special Salt - Bosch SPV2HKX41E User Manual

en Water softening system
Note: Set the water hardness determ-
ined on your appliance.
→ "Setting the water softening sys-
tem", Page 24
With a water hardness of 0 - 8 °E
you can dispense with special salt
and switch off the water softening
system.
→ "Switching off the water softening
system", Page 25
Setting the water softening sys-
tem
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 23
Press ⁠ .
2.
To open the appliance settings,
3.
press
flashes in the display.
a
Press repeatedly until the
4.
right water hardness has been set.
0, 1, 2 or 3 LEDs will light up ac-
cordingly.
→ "Overview of water hardness set-
tings", Page 23
The factory setting is level 1 (LED
A → Page 16).
To save the settings, press
5.
for 3 seconds.

Special salt

You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The amount of spe-
1
Depending on the appliance specifications
24
for 3 seconds.
cial salt required depends on the wa-
ter hardness: the higher the water
hardness, the greater the amount of
special salt required.
ATTENTION!
¡ Detergent may damage the water
softening system.
Only fill the dispenser of the wa-
▶
ter softening system with special
dishwasher salt.
¡ Special salt can damage the tub
due to corrosion.
To make sure that any special
▶
salt that escapes is washed out
of the tub, add the special salt
to the dispenser for special salt
immediately before the pro-
gramme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
1
Funnel
a