Machine Operations; St Step: Vacuum Cleaner Lower Drum Filling; Nd Step: Water Tank Filling - Advanced Solutions P-410 User Manual

FIG.1
FIG.2 FIG.2
BLACK
RED
BLUE
FIG.3
FIG.4 FIG.2
MACHINE OPERATION
1 st STEP: VACUUM CLEANER LOWER DRUM FILLING
• Disconnect the power cord of the vacuum cleaner from the
220V socket of the machine (fi g. 1)
• Unhook the closing hooks;
Lift the upper cover (fi g.2);
•
• Pour about 2 liters of clean water into the lower drum;
• Replace the upper cover and reconnect the power cord.
IMPORTANT: to avoid damage to the engine,
there must always be water in the lower drum
during suction. When the level reaches the
maximum, a fl oat will block the suction; in this
case, turn off the engine, empty the drum and
reinsert 2l. Of clean water (fi g. 2).
2 nd STEP: WATER TANK FILLING
• Disconnect the 3 silicone hoses from the machine by pulling
the plastic connectors (fi g.3)
Remove the 2 tanks and fi ll: the 10 l one exclusively with water
•
and the 5l one with a suitable diluted detergent.
• Reposition the 2 tanks in the housing: 10 l. left and 5l. to the
right. (fi g. 4)
• Reconnect the 3 pipes to the machine paying attention to the
corresponding colors: blue on the left, black in the center and
red on the right (fi g.3)
NOTES: Do not use distilled water. From time to time check the level
of water and detergent in the two tanks; the machine detects the total
lack of water to protect the resistance, but in order not to reduce the
life of the pump it is essential not to completely empty the tanks.
2