Mitsubishi WD3300U User Manual page 31

Menu operation (continued)
FEATURE menu
ITEM SETTING
ASPECT NORMAL (FULL)
NORMAL (16:9)
NORMAL (4:3)
16:9
REAL
FULL
PASSWORD DISPLAY INPUT
FUNCTION
MENU ACCESS
SPLASH ID SCREEN
MENU POSITION 1 (upper left) / 2 (lower right)
CINEMA MODE AUTO
FILM
VIDEO
VIDEO SIGNAL AUTO / NTSC / PAL /
SECAM / 4.43NTSC / PAL-
M / PAL-N / PAL-60
SETUP AUTO
OFF
3.75% / 7.5%
SCART INPUT ON / OFF
LANGUAGE
Deutsch / Français / Italiano
/
PORTUGUÊS / SVENSKA /
POLSKI
RESET ALL OK
• CINEMA MODE can be adjusted only when a TV60, TV50, 480i, 576i or 1080i signal is being displayed.
• When SCART INPUT is set to ON, nothing is output to the external monitor.
• When SCART INPUT is set to ON, normal computer signals aren't projected.
• Use a commercially available SCART-Mini D-SUB 15-pin cable when connecting this projector with an AV device equipped
with the SCART terminal.
• Some AV devices equipped with the SCART terminal aren't compatible with this projector.
FEATURE
?
A
Ë
/
/
/ English / Español /
/ / /
opt.
ASPECT NORMAL (FULL)
PASSWORD
DISPLAY INPUT
FUNCTION
MENU POSITION 1.
AUTO
CINEMA MODE
AUTO
VIDEO SIGNAL
SETUP AUTO
SCART INPUT OFF
LANGUAGE English
RESET ALL OK
FUNCTION
Input video signal is displayed at the max height (800 pixels) or max width
(1280 pixels) of the panel while its aspect ratio is maintained.
Select this setting when using a 16:9 screen.
Select this setting when using a 4:3 screen.
Regardless of the type of input signal, image is displayed at 16:9 aspect ratio
(1280 x 720 pixels). Select to expand squeezed (or horizontally compressed)
images such as DVD images to 16:9. Press the ENTER button to select
whether or not to display signals at 16:9 depending on their type. (See page
19.)
Input video signal is displayed at its original pixel size.
Select to project images in full size (1280 x 800 pixels) irrespective of type of
input signal.
Use to enable or cancel the password lock. See page 38 for details.
Use to change the position of the menu.
The film mode will be automatically activated when a film source signal is
input.
Select AUTO for normal use.
When flicker occurs on the screen, frame dropping or other incorrect display
occurs, or jaggies on slanting lines are remarkable, select either FILM or
VIDEO, which improves the symptom better.
Fixed to the film mode.
The film mode will not be activated.
When AUTO is selected, the appropriate video format is automatically
selected depending on the input signal. If the image isn't displayed correctly,
select the desired video format manually.
Select to change the SETUP mode automatically.
Select to make black lighter.
Select to make black thicker.
• When 7.5% is chosen, the brightness is decreased by the set-up cancel
function for the U.S. Choose OFF when the image is dark.
Choose ON when connecting the projector with a device equipped with the
SCART terminal that can output RGB signal. SCART terminal is used mainly
in Europe. Choose OFF normally. (Available only for the input signal from the
COMPUTER/COMPONENT VIDEO IN-1 terminal.)
Use to select the language used in the menus.
Use to reset the settings of the menu (excluding IMAGE CAPTURE,
PASSWORD FUNCTION and LANGUAGE) to the factory setting values.
EN-31