Table of Contents
Advertisement
en Before using for the first time
Before using for the first time
Before using for the
first time
Configure the settings for initial start-
Before using for the first time
up.
Performing the initial config-
uration
On initial start-up or after a reset to
the factory settings, you will need to
make settings.
Tip: Connect your appliance to a mo-
bile device. You can conveniently
change all settings via the
Home Connect app.
→ "Home Connect quick start",
Page 39
Requirement: "The appliance has
been installed and connected."
→ Page 12
"Add special salt." → Page 27
1.
"Add rinse aid." → Page 29
2.
"Switch on the appliance."
3.
→ Page 34
"Setting the water softening sys-
4.
tem." → Page 27
Overview of water hardness settings
You can find an overview of the water hardness values that can be selected
here.
You can find out how hard your water is from your local water company or by
using a water hardness tester.
Water hardness °E
0 - 8
9 - 10
11 - 12
13 - 15
16 - 20
21 - 26
27 - 38
26
Hardness range
Soft
Soft
Medium
Medium
Medium
Hard
Hard
"Set the amount of rinse aid to be
5.
dispensed." → Page 29
"Add detergent" → Page 30.
6.
Start the Programme with the
7.
highest cleaning temperature
without tableware.
We recommend you clean the ap-
pliance without tableware before
using it for the first time to remove
any marks from water or other
residues.
Tip: You can change these settings
and other "Basic settings"
→ Page 37 at any time.
Water softening system
Water softening system
Hard water leaves limescale on the
Water softening system
tableware as well as the washing
tank and parts of the appliance may
become blocked.
To ensure good dishwashing results,
you can treat the water with special
salt and the water softening system.
To avoid damage to the appliance,
water with a hardness above 9 °E
must be softened.
mmol/l
0 - 1.1
1.2 - 1.4
1.5 - 1.8
1.9 - 2.1
2.2 - 2.9
3.0 - 3.7
3.8 - 5.4
Setting value
H:00
H:01
H:02
H:03
H:04
H:05
H:06
Advertisement
Table of Contents
