Mitsubishi HC3800 Control Manual page 6

[Example 1] When setting the AUTO POWER ON to ON. (Figures and symbols enclosed in quotation marks are
ASCII codes.):
Sending commands
from the PC, etc.
30 30 41 50 4F 4E 31 0D
'0' '0' 'A' 'P' 'O' 'N' '1' '
[Example 2] When setting the CONTRAST R of the COLOR TEMP.-USER to +10, the CONTRAST G to 0, and the
CONTRAST B to -5. (Figures and symbols enclosed in quotation marks are ASCII codes.):
Sending commands
from the PC, etc.
30 30 50 2B 31 30 2B 30 30 2D 30 35 0D
'0' '0' 'P' '+' '1' '0' '+' '0' '0' '-' '0' '5' '
[Example 3] When checking the TINT setting (when the TINT is set to +10). (Figures and symbols enclosed in quo-
tation marks are ASCII codes.):
Sending commands
from the PC, etc.
30 30 53 0D
'0' '0' 'S' ' '
• To set TINT at 0, enter +00. (-00 is invalid.)
[Example 4] When setting the REFERENCE of GAMMA MODE-USER1 to CINEMA (+2), ADJUST MODE to RED
(R), HIGH to -2, MID to +3 and LOW to 0. (Figures and symbols enclosed in quotation marks are
ASCII codes.):
* There is no command for selecting ALL for ADJUST MODE. Even when you want to set all the three
colors to the same value, send a command for each of R, G, and B respectively.
Sending commands
from the PC, etc.
30 30 47 53 55 31 52 2B 32 2D 30 32 2B 30 33 2B 30 30 OD
'0' '0' 'G' 'S' 'U' '1' 'R' '+' '2' '-' '0' '2' '+' '0' '3' '+' '0' '0' '
'
30 30 41 50 4F 4E 31 0D
'0' '0' 'A' 'P' 'O' 'N' '1' '
'
30 30 50 2B 31 30 2B 30 30 2D 30 35 0D
'0' '0' 'P' '+' '1' '0' '+' '0' '0' '-' '0' '5' '
30 30 53 2B 31 30 0D
'0' '0' 'S' '+' '1' '0' '
'
30 30 47 53 55 31 52 2B 32 2D 30 32 2B 30 33 2B 30 30 OD
'0' '0' 'G' 'S' 'U' '1' 'R' '+' '2' '-' '0' '2' '+' '0' '3' '+' '0' '0' '
Status code
from the projector
'
Status code
from the projector
'
Status code
from the projector
'
Status code
from the projector
6
Description
Command for setting the AUTO
POWER ON to ON
Command receipt confirmation
(Command echo back)
Description
Command for setting the picture
control
Command receipt confirmation
(Command echo back)
Description
Command for checking the TINT
setting
Check result (+10)
Description
Command for setting GAMMA
MODE-USER1
Command receipt confirmation
' (Command echo back)