Table of Contents
Advertisement
Installation
C
B
CAUTION
pump, cable and plug are not showing any damage due
to transportation and storage.
• Connect the hose to the hose into the connection most
suitable for the needs (A). Use a clamp to fasten the soft
hoses and a soldered flange for steel hoses.
• To submerge the pump, tie one end of rope "not
included" onto the transportation handle (B).
CAUTION
float switch to carry or hang the pump.
• Tie the other end of the rope to some fixed point to
support the pump not deeper than 22.9 ft under the
water surface. Make sure the suction base openings are
not partially or totally obstructed.
a brick is recommended.
• Double check there are no obstacles so that the float
switch can move freely (C).
NOTE
The minimum diameter where the pump is set
shall be 15.7" so that the float switch can move freely.
A
• Before installing double check the
• Never use the power cable or the
Setting the pump onto
ENGLISH
7
Advertisement
Table of Contents
