Table of Contents
Advertisement
Installation
C
B
CAUTION
pump, cable and plug are not showing any damage due
to transportation and storage.
• Connect the hose to the hose into the connection most
suitable for the needs (A). Use a clamp to fasten the soft
hoses and a soldered flange for steel hoses.
• To submerge the pump, tie one end of rope "not
included" onto the transportation handle (B).
• Hold the rope and immerse the pump.
CAUTION
float switch to carry or hang the pump.
• Tie the other end of the rope to some fixed point to
support the pump no deeper than the maximum depth
marked for each model under the water surface and no
less than 20" away from the bottom to prevent mud,
particles, algae or residue blocking the pump.
• Double check there are no obstacles so that the float
switch can move freely (C).
NOTE
The minimum diameter where the pump is set
shall be 15.7" so that the float switch can move freely.
A
• Before installing double check the
• Never use the power cable or the
ENGLISH
7
Advertisement
Table of Contents
