Advertisement
Quick Links
Mojave ™ ESS Power Supply
Purpose and Scope
These instructions detail how to install an AC-to-DC power supply in the Mojave™ Energy
Storage System (ESS). This power supply will enable firmware updates to the ESS battery.
The process for firmware updates is specified elsewhere and is not included here.
These instructions require familiarity with both the Mojave™ inverter and the ESS battery.
For more information, refer to the Mojave™ Inverter/Charger Quick Start Guide and the
Mojave™ ESS Operator's Manual.
CAUTION: Hazard to Equipment
Make certain to remove all power to the Mojave™ ESS and any other equipment.
Follow all instructions included in this document.
CAUTION: Equipment Shutdown
This power supply must be installed before performing firmware updates to the ESS battery.
Failure to install it will result in complete shutdown of both the Mojave™ inverter and ESS battery.
Mojave ™ Chassis
OutBack Power has manufactured Mojave™ inverters with two different chassis. These can
be identified by the conduit knockout pattern. Follow the appropriate installation instructions.
If the knockouts appear in
the pattern shown in 1,
follow the instructions on
page 2.
1
900-00280-01-001 Rev A
Installation Instructions
Figure 1
Mojave™ chassis types
If the knockouts appear in
the pattern shown in 2,
follow the instructions on
page 4.
2
1
Advertisement
Related Manuals for OutBack Power Mojave ESS
Summary of Contents for OutBack Power Mojave ESS
- Page 1 Failure to install it will result in complete shutdown of both the Mojave™ inverter and ESS battery. Mojave ™ Chassis OutBack Power has manufactured Mojave™ inverters with two different chassis. These can be identified by the conduit knockout pattern. Follow the appropriate installation instructions.
-
Page 2: Power Supply
Power Supply Chassis 1 Instructions To install the power supply in Chassis 1: 1. Remove the inverter’s cover as shown in Figure 2. Figure 2 Remove cover 2. Attach the wiring kits to each end of the power supply as shown in Figure 3. ... -
Page 3: Installation Instructions
Installation Instructions 4. Mount the power supply as shown in Figure 4. Four PEM nuts are installed in the lower left section of the chassis. Orient the power supply so that the DC wiring is on the left, AC on the right. ... - Page 4 Power Supply Chassis 2 Instructions To install the power supply in Chassis 2: 1. Using a 5 mm hex (Allen) wrench, remove 4 screws from the inverter’s cover. Remove the cover. See A in Figure 6. 2. Open the wiring compartment door by pressing the latch at B. The door swings to the right.
- Page 5 Installation Instructions 5. Mount the power supply as shown in Figure 8. Four mounting holes are located in the lower section of the chassis. Orient the power supply so that the DC wiring is on the left, AC on the right. ...
-
Page 6: Contact Information
IMPORTANT IMPORTANT: This power supply is only intended to be connected for the firmware update process. Once the update is complete, the wiring kits should be disconnected and removed. Replace the wires in their original shipping bag (or a similar bag) and tape them to the ...