John Adams eZee Beads 3D Little Treats Instructions

What's in the box?
• eZee Beads
• Bead Storage Tray
• Water Sprayer
• B ead Tool
• Design Cards
• P lastic Pins
helping to line up bead layers)
The following diagrams show how eZee Beads work. Read through these instructions
before you start to make your 3D characters as explained overleaf.
Select a design card and
slide it into the base of
the bead tray with the
design facing upwards.
Remove your design by using the spatula end of the bead tool, carefully lifting and
loosening the beads upwards around the shape. Next use your fingers to pull it up from the pegs.
As you lift up the shape, if any of the beads come detached from the rest, put the shape back down
onto the pegs, re-spray that area with water and leave to dry again.
When using eZee beads, the pointed end of the bead tool is handy for lifting out any dry beads which
are in the wrong place.
After removing your eZee Bead design, there may be some bead colour left on the tray.
This will not interfere with future designs. If you would like to remove these marks, clean the
tray with warm soapy water and allow to dry.
(a handy tool for
INTRODUCTION
Start by pushing the
coloured beads onto the
pegs of the tray matching
the beads to the colours
on the cards.
Take out the design
card. Using the water
bottle, spray enough
water to thoroughly
wet all the beads.
Allow at least 30
minutes to dry and
then remove your bead
design from the tray.