Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Laser NRGVAULT PV1500
Summary of Contents for Laser NRGVAULT PV1500
- Page 1 User Manual PWR-PV1500-PS...
-
Page 2: Maintenance
INTRODUCTION This product is a portable energy storage power generator. It can be used as a power source for emergency relief, outdoor camping, office equipment, entertainment and much more. It is compact enough for portability but capable enough to power small to large appliances. MAINTENANCE •... -
Page 3: General Safety
GENERAL SAFETY The NRGVault range of portable power stations has been made to the highest standards for safety and reliability. Please retain the user manual for important safety information about your device. This manual will help you learn the features and specifications of the device to assist with operability and satisfaction during use. - Page 4 TIPS FOR SAFE CHARGING 1. AVOID OVERCHARGING. Disconnect power stations and devices after the battery reaches a full charge. Leaving devices on a power station too long may cause them to overheat and can reduce battery life. 2. PICK THE RIGHT POWER OUTPUT. Take special care to match the correct voltage and amp values your device requires when using a power station.
-
Page 5: What's In The Box
WHAT’S IN THE BOX • PWR-PV1500-PS Portable Power Station • AC Charging Cable • User Manual... -
Page 6: Product Specifications
PRODUCT SPECIFICATIONS Item Description Battery Cell Type: LiFePO4 Battery Cell Model: 32700 3.2V/6000mAh x 64 Rated Capacity 1228Wh (25.6V/48Ah) Lifecycle 2000 cycles to 80% Battery Under/Over Voltage Protection, Over Current Protection, Management Short Circuit Protection, Overcharging Voltage Protection, System Over Temperature Protection, Overload Protection. MPPT Supports Solar Power MPPT charging Housing... -
Page 7: General Specifications
GENERAL SPECIFICATIONS Item Parameter Battery Cell Standard 3.2V Voltage Cells Configuration 8S8P Battery Pack Voltage 25.6V Output Waveform Pure Sine Wave Operating Environment 0~40°C 20%~90% Working Humidity No condensation at 20-90% of humidity Normal indoor storage temperature. Storage Temperature Recommended storage temperature: 0 ~ 25°C (Range) Recommend: Recharge every 3 months. - Page 8 USE CASE (approximations only) Table Lamp Mini Fridge 220 hours 10 - 15 hours iPhone 12 Cordless Drill 40+ Charges 15+ Charges Tablet 20 hours 30+ Charges CPAP Device Laptop 5 – 6 hours 10-15 Charges Camera 9 hours 30+ Charges Bluetooth Speaker Drone 20+ Charges...
-
Page 9: Product Diagram
PRODUCT DIAGRAM 1. DC on/off Switch 8. AC Output Ports 9. LCD Display 2. DC Output Port 10. USB on/off Switch 3. Car Socket 11. QC3.0 USB-A Ports X 4 4. DC Input Port 12. PS100W USB-C Ports X 2 5. -
Page 10: Lcd Display
LCD DISPLAY Battery failure/low Battery Power Level % voltage indicator Battery high/low Battery Information Battery Power Level temperature indicator Indicator Battery Lock Protection AC Input DC Input Input Indicator Solar Input Input Power AC Output Indicators DC/Car Outlet Output Output Indicator USB Output Indicators Output power Minutes... - Page 11 CHARGING • Please charge the PWR-PV1500-PS before using. • Charge the battery to 80% before extended storage. Check the PWR-PV1500-PS remaining power level every 3-6 months and charge again. • There are 3 input ports on the PWR-PV1500-PS: 1 x AC input port. 1 x Solar input port.
-
Page 12: Solar Charging
SOLAR CHARGING • The PWR-PV1500-PS supports Solar Panel charging rated at 90W. • Solar power can be used to charge the PWR-PV1500-PS with a maximum power of 300W through the XT60 port (figure 6 in Product Diagram) • A full charge from a 300W Solar Panel will take between 5-10 hours (dependant on sunlight intensity). -
Page 13: Car Charging
CAR CHARGING • PWR-PV1500-PS supports car charging rated at 200W. • The 12V socket in a car can be used to charge the PWR-PV1500-PS with a maximum power of 200W through the DC port (figure 4 in Product Diagram). • A full charge via a 12V car charger will take approx. 14-16 hours. Note: A 12V DC5521 cable (sold seperately) is required. - Page 14 HOW TO USE AC OUTPUT Under the condition that the total power does not exceed 1500W, all AC outlets can work together at the same time. 1. Make sure there is no device connected to the AC input, then long press the main power button 3 seconds to turn on. The main power indicator and the screen lights up, then enters the standby state.
- Page 15 HOW TO USE AC OUTPUT continued... NOTE: • When the AC out function is turned on, the AC icon on the LCD display will light up, then perform a system power check for approx 8-10 seconds. After the checks are complete, AC power output will be available.
- Page 16 HOW TO USE DC OUTPUT 1. Long press the main power button to turn on. The main power indicator and the screen light up, then enters the standby state. 2. Plug in the DC device. 3. Tap the DC on/off switch to turn on the DC function. 4.
- Page 17 HOW TO USE USB OUTPUT 1. Long press the main power button to turn on. The main power indicator and the screen light up, then enters the standby state. 2. Tap the USB on/off switch to turn on the USB function. 3.
-
Page 18: Troubleshooting
TROUBLESHOOTING DEVICE NOT CHARGING: • Power off/on your device and try charging again. • Try using another charging cable from your device to the PWR-PV1500-PS. • If using AC or DC output, make sure their respective switches are set to ON. •... - Page 19 TROUBLESHOOTING continued... HOW DO I CHARGE THE PWR-PV1500-PS? - The PWR-PV1500-PS has 3 charging inputs. AC (Wall Socket), XT60 (Solar Panel) and DC (Car). An AC cable is included for charging via a wall socket. The XT60 and DC cables are not included.
- Page 20 Thank you for your purchase! To get the most out of your product please read the user manual carefully and keep for future use. For specific information relating to your product such as Spare Parts, FAQs, Warranty claims, and more, please scan the following QR code:...
- Page 21 Visit our websites www.laserco.com.au www.nrgvault.com.au Check us out at www.youtube.com/lasercoau...