Related Manuals for Runpotec GF3
Summary of Contents for Runpotec GF3
- Page 1 I N S T R U C T I O N M A N U A L GF3 Glass Fiber Ø 3 mm Cable pulling system WWW. RU NP O T EC .C OM...
- Page 2 Overview Introduction Safety information GF3 description Scope of delivery Commissioning / meter counter Easy and quick service access Automatic glide back protection Repairs Technical information glass fiber rod Application Cable pulling loop with RTG 6 thread Accessories / combination products...
- Page 3 Scope of delivery Sample image RUNPOTEC GmbH – Irlachstrasse 31 – A-5303 Thalgau Tel.: +43-6235-20 335 – Fax: DW 35 – office@runpotec.com...
-
Page 4: Safety Information
Safety information Read the safety information on www.runpotec.com before use. The GF3 - Glass Fiber Ø 3 mm is used exclusively for pushing into pipes Ø 10 - 50 mm and for pulling in cables and lines. No liability is accep- ted for any other use! Please note the information on the special glue (item no. - Page 5 1 decimal place after the point Negative measured value possible (minus in front of the value) Easy and quick service access On the back of the GF3 box, loosen the screw in the middle to be able to remove the accessory box .
- Page 6 Automatic glide back protection Prevents the fi berglass rod with the guiding head incl. kink pro- tection from slipping back into the GF3 box and thus always being at hand. Repair etc.: press the glide back protection to the left to be able to push the fi berglass rod with the guiding head including kink protection into or out of the box.
- Page 7 6 x Adhesive joint, 1 x Eyelet, 1 x Coupling joint, 1 x Starting head GF3 – RC2 – Special offer Item no. 1 x GF3 Glass Fiber Ø 3 mm – 11146 cable pulling system – 30 m with integrated digital meter counter – ft/m...
- Page 8 For small- to mid-sized Ø 16 mm – 40 mm cable drums Cable pulling system Profi cable roller GF3 Glass fiber rod Ø 3 mm XB 500 – X BOARD For all cable drums, Integrated digital cable bundles and pipes meter counter –...
Need help?
Do you have a question about the GF3 and is the answer not in the manual?
Questions and answers