Advertisement
Quick Links
®
Installation, Operation and Maintenance Manual
Please read and save these instructions for future reference. Read carefully before attempting to assemble, install,
operate or maintain the product described. Protect yourself and others by observing all safety information. Failure
to comply with these instructions will result in voiding of the product warranty and may result in personal injury
and/or property damage.
Installation Instructions For Manual Quadrant
Part Number 828599
No.
Qty
1
1
Standoff bracket
2
1
Extension pin
3
1
Retaining clip
4
1
⁄
in. Manual quadrant
1
2
5
1
Open and close labels
6
2
Tek screws
7
1
Washer
Tools Required:
⁄
in. hex nut driver
5
16
⁄
in. electric drill
3
8
⁄
in. open end wrench
1
2
Description
Document Number 464599
Extension Pin, Manual Quadrant Kit,
and Cable Operator Option
Table of Contents
Manual Quadrant Installation . . . . . . . . . . . . . 1
Cable Operator with Round Ceiling Cup . . . . . . . 2
Cable Operator with Wall/Ceiling Plate . . . . . . . . 3
Note: For Dampers Installed In Ducts
Extended control shaft is installed from outside of duct
after damper is installed. Install as shown above.
MBD-15
Crossover blade
axle
DO NOT ATTACH
control shaft here
MBD-15
1
Advertisement
Related Manuals for Greenheck MBD-15
Summary of Contents for Greenheck MBD-15
- Page 1 Document Number 464599 MBD-15 ® Extension Pin, Manual Quadrant Kit, and Cable Operator Option Installation, Operation and Maintenance Manual Please read and save these instructions for future reference. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with these instructions will result in voiding of the product warranty and may result in personal injury and/or property damage.
- Page 2 Mounting plate 1036710 ⁄ in. bit driver Cable operator 1036540 ⁄ in. hex key #10 Tek screw 415555 ⁄ in. hex key Cap screw 415474 415455 #14 Tek screw 417432 Crossover blade axle DO NOT ATTACH control shaft here MBD-15...
- Page 3 ⁄ in. bit driver Mounting plate 1036710 ⁄ in. hex key Cable operator 1036540 ⁄ in. hex key #10 Tek screw 415555 Cap screw 415474 415455 #14 Tek screw 417432 Crossover blade axle DO NOT ATTACH control shaft here MBD-15...
- Page 4 As a result of our commitment to continuous improvement, Greenheck reserves the right to change specifications without notice. Product warranties can be found online at Greenheck.com, either on the specific product page or in the literature section of the website at Greenheck.com/Resources/Library/Literature.