MK -101 Maintenance Information
  1. Manuals
  2. Brands
  3. MK Manuals
  4. Saw
  5. MK-101
  6. Maintenance information

MK -101 Maintenance Information

Tile saw
Hide thumbs Also See for MK-101:
1
2
3
4
5

Advertisement

Table of Contents

MK-101
TILE SAW
OWNER'S MANUAL &
Maintenance Information
OPERATING INSTRUCTIONS
CAUTION:
Read all safety and
operating instructions
before using this
equipment
Enter the Serial Number of your new saw in the
space below. The Serial Number is located on the
left side of the blade guard.
SERIAL NUMBER:
NOTE:
For your (1) one year warranty to be effective,
complete the warranty card (including the Serial
Number and mail it in as soon as possible.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MK-101 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for MK MK-101

Summary of Contents for MK MK-101

  • Page 1 MK-101 TILE SAW OWNER’S MANUAL & Maintenance Information OPERATING INSTRUCTIONS CAUTION: Read all safety and operating instructions before using this equipment Enter the Serial Number of your new saw in the space below. The Serial Number is located on the left side of the blade guard.

  • Page 2: Maintenance And Troubleshooting

    (See V-belt Inspection) 2. Maintenance Following Use: To extend the life of the MK-101, the following procedure should be performed after each use. Lubricate all points listed below with light oils such as, 3 in 1, WD-40, etc. ON/OFF...

  • Page 3: Monthly Maintenance

    Assembly is tight and in Bolts are tight Strap is tight good condition Turn Counter- Blade Guard clockwise to remove Pivot Shaft Remove the Blade Guard Lubricate the Blade Guard Pivot Shaft Page 27 MK-101 Revision 4/01, Effective Date April 29, 2001...

  • Page 4: Flow Adjustment

    NOTE: If flow to the diamond blade requires adjustment, perform the following actions. Press Tab to Restrict Flow Pull Tab to loosen Increase cooling flow by Reduce cooling flow by releasing the Flow Adjusting Pressing down on the Flow Clamp Adjusting Clamp Page 28 MK-101 Revision 4/01, Effective Date April 29, 2001...

  • Page 5: Blade Dressing

    “wander” or bend giving the illusion of an alignment problem. When this occurs, the blade will need to be dressed. The diamond blade can be dressed using the MK Dressing Stick (part number 152972) and by following the steps below.

Table of Contents