GE Lumination DS Series Installation Manual page 4

Reset the Daintree Wireless Fixture Adapter
Diffuser and light engine must be removed first (see steps above). Daintree Wireless Adapter is supported by two screws.
1
Press and hold the Reset button on
the WFA100 for 3 seconds to reset
the unit. Release the button when
the green Joined
Error x LED begin flashing.
For further troubleshooting,
communicate directly with Daintree
Networks at www.daintree.net
www.gelighting.com
GE and the GE Monogram are trademarks of the General Electric Company. All other trademarks are the property of their respective owners. Information provided is subject to
change without notice. All values are design or typical values when measured under laboratory conditions. GE Lighting is a business of the General Electric Company. © 2016 GE.
IND265 Eng (Rev 08/15/16)
GE2029-8388
x
Error/Test—On when the Wireless Adapter is in an
error state. Flashes to indicate unit Reset and during
Installation Test Mode (red).
x
Joined—On when the Wireless Adapter has joined a
ZigBee
sensor Installation Test Mode (green).
Power—On when power is applied to the Wireless
Adapter (green).
x
LED and the red
network. Flashes to indicate Reset and during
®
x