GE Lumination DS Series Installation Manual page 3

4
While supporting light engine
use flat-head screwdriver to
disconnect retention wire from
light engine.
7
Push end of light engine back up
into housing so that it rests above
retention clips. Ensure no wires
rest below light engine.
Driver Removal and Replacement
Diffuser and light engine must be removed first (see steps above). Power supply is supported by four screws.
1
Taking note of any optional
secondary circuits, disconnect driver
leads from push-in wire connectors.
NOTE: Units equipped with
emergency battery backup are NOT
field servicable.
New light engine
5
Reconnect retention wire from
luminaire to new light engine.
Click!
8
Push other end of light engine back
up into housing. Both retention clips
should make an audible noise when
the light engine is properly secured.
Function Driver
Line Black
Neutral White
DC + Red
DC – Blue
Dim + Violet
Dim – Grey
2
Attach replacement leads according to the table
above. Do not connect DC driver output leads to
14AWG wires or through-wiring harness.
*Line and neutral may be attached to optional
brown and brown/white branch circuit.
6
Reconnect LED driver wires to
light engine wire connectors.
Red to red, blue to black.
Wire Colors
Fixture Light Engine
Black* X
White* X
X Red
X Black
Violet X
Grey X