RE 30159-B/12.14 | VT-HNC100...3X/S...
CAUTION!
CAUTION!
CAUTION!
CAUTION!
Risk of injuries when assembling under voltage!
If you do not switch off voltage supply before assembling the product, you may
get injured, destroy the product or damage system components.
Always switch off power supply to the relevant system component before as-
f
sembling the product.
Risk of personal injuries and material damage!
Incorrect energy supply may lead to uncontrolled valve positions. These could
possibly result in malfunctions or failure of the VT-HNC100...3X/S... and cause
injuries.
Exclusively use a power pack with safe electrical isolation.
f
Always comply with the country-specific regulations.
f
Connecting or disconnecting plugs under voltage will destroy the unit!
Connecting or disconnecting plugs under voltage causes high potential differ-
ences which can destroy the unit.
Switch off power supply to the relevant system component before assembling
f
the unit or when connecting and disconnecting plugs.
Short-circuit or failures due to penetrating humidity and contamination
The housing of the VT-HNC100...3X/S... is perforated. Contamination and liquids
may easily enter and cause failures or short-circuits!
Safe functioning of the VT-HNC100...3X/S... is thus no longer ensured.
Always provide for absolute cleanness when working on
f
the VT-HNC100...3X/S....
For the pin assignments of the VT-HNC100...3X/S... please refer to chapter 4.1.
f
In the case of VT-HNC100..3x as of series 31 with Sercos III interface (see
type code VT-HNC100-1-3X/S-I-30/000) firmware versions higher than 06V26
must be used.
Further information and download:
http://www.boschrexroth.com/hnc100
Should you have further queries, please contact
eMail: support.nc-system@boschrexroth.de
Bosch Rexroth AG
Series
17/24
Assembly