Display Mode Function; Important Information - PROMETHEUS PRO-1 User Manual

Multi functional kiln
Table of Contents

Advertisement

IMPORTANT INFORMATION

•If no action is taken for a long time you'll need to start
programing again by pressing to the
•If you make a mistake during any point of the programing, turn
your kiln off and on again to start over.
•Place your kiln on a fire proof surface (ceramic, marble etc.)
with min. 30 cm space in all sides.
•Use a heat resistant glove when loading and unloading your
kiln.
•When transporting, place your kiln back side down on the
vehicle.
Now the upper line of your DC shows the current
temperature of your heating chamber. In the lower
line, it shows you the firing temperature that is set
for your kiln. Now your kiln is ready. Take the
switch to HEATER position and your kiln starts to
heat.
To stop the heating process, take your switch to
the «OFF» position. The numbers on your DC will
disappear.
What is the function of the DISPLAY mode?
DISPLAY mode stops the heating of your kiln. In this
mode, you can see the current temperature inside
your firing chamber and your target temperature
and you can change your target temperature. To
start heating, you need to turn you switch to the
HEATER position.
MODE
key.
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PRO-1 and is the answer not in the manual?

Table of Contents