Table of Contents
Advertisement
Procedures for Removing Model V10 Spool Seals
Handle End
A
A
A
Figure 3. Model V10 Spool Seal Removal
Model V10 Service Bulletin HY14-2701-M1/US - TORO Specific
Positioner End
B
1. Remove the handle and positioner hard-
ware from the valve section.
2. Insert a punch or screwdriver through the
spool clevis. While watching the positioner
B
end, slowly pull the spool toward the handle
end. Stop when the spool seal is exposed
as shown.
3. Using a small seal pick, carefully
remove the spool seal from the positioner
end.
B
4. Push the spool back through the housing
and out the positioner end.
5. Remove the remaining spool seal with
the seal pick.
6
Revision: 01-01-2005
Advertisement
Table of Contents
