Page 1
ORDER NO. ACED040340C7 AUTOMOTIVE AFTERMARKET CQ-C9800U / CQ-C9700U Removable Full Front MP3 WMA CD Player/Receiver with Full Dot Matrix Display and CD Changer Control SPECIFICATIONS Specifications*...
Page 2
Test Voltage 14.4V Negative Ground Current Consumption Less than 2.2A / (CD mode; 0.5W × 4-speaker) Maximum Power Output <CQ-C9800U> 70W × 4(at 1kHz) / Volume Control Maximum <CQ-C9700U> / 60W × 4(at 1kHz) / Volume Control Maximum Tone Adjustment Range Bass: ±28dB at 20Hz / Treble: ±...
Dimensions (W×H×D)** 7”×1-15/16”×6-1/8” / (178×50× 155mm) Weight** 3 lbs. 12oz (1.7 kg) * Specifications and the design are subject to possible modification without notice due to improvements. ** Dimensions and Weight shown are approximate. ** Above specifications comply with EIA standards. 2004 Matsushita Electric Industrial Co., Ltd.
- Customizeble Graphics - CD Changer Control - Dynamic Control (Bass/ treble) - The difference among two models CQ-C9800U and CQ-C9700U are mentioned below 3. REPLACEING THE FUSE Use fuses of the same specified rating 15 amps. Using different substitutes or fuses with higher ratings, or connecting the unit directly without a fuse, could cause fire or damage to the stereo unit.
11. TERMINALS DESCRIPTION 11.1. Main Block IC601 : C2CBKG000017...
Page 11
Port Description FM AM CD 1 PANEL_OPEN PANEL OPEN 5.3 5.3 5.3 detection 2 PANEL_CLOSE PANEL CLOSE 5.3 5.3 0 detection 3 FR/WP 4 BATT BATT detection 4.9 5 5 ACC ACC detection 4.9 5 6 SDA_DSP Electronic VOL I/O 4.4 4.7 4.7 data 7 SCLK_DSP Electronic VOL 4.5 4.7 4.7...
Page 12
Port Description FM AM CD 30 CD_FS 4.9 4.9 2.8 31 RESET_DSP 4.9 4.9 4.9 32 Avdd Power supply 5.1 5.1 5.1 of D/A converter 33 AVREF Reference 5.1 5.1 5.1 voltage for D/A converter 34 AVGND Reference GND for D/A converter 35 AVSS Grand for A/D...
Page 13
Port Description FM AM CD 55 V_CNT2(NC) No Connection 56 NC No Connection 57 EXT_MUTE TEL/ 5 5.1 NAVI_MUTE input 58 AMP_CONT External AMP 4.9 4.9 5 control 59 BZ_OUT(NC) No Connection 60 ANT_CONT Motor antenna 4.9 4.9 0 control 61 DIM1 Dimmer control output...
Page 14
Port Description FM AM CD 78 X0A Connecting to 79 Vss 80 X1 Crystal oscillator input 81 X2 Crystal oscillator output 82 Vdd Power supply 5 5.1 83 P00 Pldaun port for writing 84 P01 Pull-up port for 5.1 5.1 5.1 writing 85 AM PWR-...
Port Description FM AM CD 98 S_LED Security LED control output 99 PANEL_IN PANEL detect 5.1 5.1 5.1 100 EP_/CS EPROM Existence Detection 11.2. Display Block IC900 : C2DBKJ000187 Port Part Name & Description 1 D0 FLASH D0 2 D1 FLASH D1 3 D2 FLASH D2...
Page 16
Port Part Name & Description 32 A13 FLASH A12 33 A14 FLASH A13 34 A15 FLASH A14 35 A16 FLASH A15 36 A17 FLASH A16 37 A18 FLASH A17 38 A19 FLASH A18 39 A20 FLASH A19 40 VSS Connecting to GND 41 NC No Connection 42 NC...
Page 17
Port Part Name & Description 64 LCD_RESET LCD driver reset control output 65 FLASH_RESET FLASH reset control output 66 A21 FLASH_A20 67 NC No Connection 68 LCD_CS LCD driver chip selection output 69 NC No Connection 70 LED_R Red LED control (PN0) 71 LED_G Green LED control...
Page 18
Port Part Name & Description 91 KI2 Key return signal 2 input 92 KI3 Key return signal 3 input 93 KI4 Key return signal 4 input 94 KI5 Key return signal 5 input 95 VCC Connecting to VDD 96 VSS Connecting to GND 97 KI6 Key return signal 6...
Port Part Name & Description 120 NC Connecting to GND 11.3. CD Servo Block IC401 YESAM176 Port Descriptions I/O (V) CVSS1 GND CVSS2 GND DVSS1 I/O system (3.3V) power supply Address bus of FLASH HD7(NC) No Connection Address bus of FLASH 10 A14 11 A15 12 /CVDD1 CORE CPU system (1.6V)
Page 20
Port Descriptions I/O (V) No Connection 30 /HOLD 31 SUBQ SUBQ input Operation mode setting (external pull-up) 33 DVDD2 I/O system (3.3V) power supply 34 CVSS4 GND 35 (GND) No Connection 37 CVSS5 GND No Connection No Connection 40 DVSS2 GND 41 CLK C AUDIO bit clock input 42 SCK...
Page 21
Port Descriptions I/O (V) No Connection No Connection 63 /NMI 64 /INT0 65 /INT1 66 BLKCK Subcode block clock pulse input 67 /INT3 68 CVDD4 CORE CPU system (1.6V) power supply 69 SW1 Mechanics deck SW1 input 70 CVSS7 GND 71 MCLK Clock output (To Servo DSP)
Page 22
Port Descriptions I/O (V) 95 CLKENA Oscillation output Cainabl signal 96 ×1 Crystal Connection 97 ×2 Crystal Connection 98 (VDD) Reset signal input 99 D0 Data base of FLASH ROM I/O 3.4 100 D1 101 D2 102 D3 103 D4 104 D5 105 A16 Address bus of FLASH...
Part No. Part Name & Description Q'ty Remarks Item Inner Carton available Transport Label available EL Wire Label available Polyethylene Bag available Packing Pad Front available Packing Pad Rear available Instruction Kit available YEFM284204 Operating Instructions Warranty Card for USA (1) Not available Warranty Card for Canada...
Page 35
- Order intake period is basically six months after the first shipment. 5. "A" or "B" marks in remarks column are indicated as follows : - A : CQ-C9800U - B : CQ-C9700U Ref. No. Part No.
16. CD PLAYER PARTS LIST Notes : 1. Be sure to make your orders of replacement parts according to this list. 2. Important safety notice: Components, identified by mark have special characteristics important for safety. When replacing any of these components, use only manufacturer's specified parts. 3.
Page 60
location of the parts shown in the exploded drawing, as in a road map. 4. The marking (RTL) indicates that Retention Time is limited for this item. After the discontinuation of assembly in production, the item will continue to be available for a specific period of time. The retention period of availability is dependent on the type of assembly, and in accordance with the laws governing part and product retention.
Page 61
Ref. No. Part No. Part Name & Description Remarks C112 YESCC183 Ceramic, 0.0022 F 50WV C113 YESCC208 Ceramic, 0.0015 F 50WV C114 YESCC207 Ceramic, 0.001 F 50WV C115 YESCC187 Ceramic, 0.1 F 25WV C116 YESCC187 Ceramic, 0.1 F 25WV C121 YESCC269 Ceramic, 10 F 6.3WV...