Advertisement
Adjusting The Quick Release
If the quick release doesn't hold the stem snug in place, you
Open
Close
will need to adjust it.
Quick Release
Open the quick-release lever. Turn the adjustment nut clockwise
one half turn while keeping the lever from turning. Close the
lever. Repeat this procedure until the stem is held snug in place.
If the quick release is too snug to close, it will need to be
Lever
adjusted.
Adjustment
Nut
While the quick-release lever is open, turn the adjustment nut
counterclockwise one quarter turn while keeping the lever from
turning. Close the lever. Repeat this procedure until the stem is
held snug in place and the quick release is closed.
Hand Brake Maintenance
Refer to inset drawing 1. Locate the adjustment barrel (B) and
1
the lock nut (A) on the hand brake. Turn the lock nut (A) coun-
A
terclockwise to loosen it. Next, turn the adjustment barrel (B)
B
counterclockwise a few turns. Then, turn the lock nut (A)
clockwise to retighten it. Repeat until the hand brake is properly
adjusted.
If the movement of the hand brake needs to be further adjusted,
the lower end of the brake cable can be adjusted.
Refer to inset drawing 2. Locate the adjustment barrel (C) and
the lock nuts (D and E) near the end of the brake cable. Using a
small open-end wrench, turn the outer lock nut (E) counter-
2
clockwise to loosen it. Next, turn the adjustment barrel (C)
C
counterclockwise a few turns. Then, turn the inner lock nut (D)
D
clockwise to tighten it.
E
Ordering Parts
To order replacement parts, call toll-free 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding
holidays). When ordering parts, please mention the model number (PFSC09990) and the number and description of the parts needed.
Advertisement
