Advertisement
Warning Decal Placement
The decals shown at the right have been placed on the
scooter. If a decal is missing or illegible, please call our
Customer Service Department toll-free at 1-800-999-3756,
Monday through Friday, 6 a.m. until 6 p.m. Mountain
Time, to order a free replacement decal. Apply the replace-
ment decal in the location shown.
Setup
Before using the scooter, make sure that the scooter is set up
as described and that all parts are securely tightened.
1.
Firmly press the thumb tab and pivot the upright up until it
locks in a nearly vertical position.
2.
Insert the handles into the stem until the push pins are visi-
ble in the holes in the stem.
3.
Open the quick-release lever. Depress the push pin on the
stem, and slide the stem up until the push pin is visible in
one of the three holes in the upright. With the stem at the
desired height, close the quick-release lever so that it is
snug against the upright. If the quick release is not snug,
see ADJUSTING THE QUICK RELEASE on the next
page.
Storage
1.
Open the quick-release lever. Depress the push pin on the
stem and slide the stem down into the upright. Close the
quick-release lever.
2.
Depress the push pins and remove the handles from the
stem. Press the handles into the storage clip on the upright.
3.
Pull the thumb tab and pivot the upright down until it locks
in the horizontal position.
Handle
Hand
Push Pins
Brake
Stem
Quick
Release
Push Pin
Upright
Upright
Thumb Tab
Thumb Tab
Head Frame
Brake
Storage Clip
Advertisement
