Maserati Ghibli Owner's Manual page 125

A - Programming a Rolling Code
For programming garage door
openers that were manufactured after
1995. These garage door openers can
be identified by the "LEARN" or
"TRAIN" button located where the
hanging antenna is attached to the
garage door opener. It is NOT the
button that is normally used to open
and close the door.
The name and color of the button may
vary by manufacturer.
• Place the ignition device to the RUN
position.
• Place the hand-held transmitter 3 to
8 cm (1 to 3 inches) away from the
®
HomeLink button you wish to
program.
• Simultaneously press and hold both
®
the Homelink button you want to
program and the hand-held
transmitter button.
• Continue to hold buttons until the
instrument cluster display changes
from "CHANNEL # TRAINING" to
"CHANNEL # TRAINED", then release
both buttons.
NOTE:
• It may take up to 30 seconds or
longer in some cased for the channel
to train.
• If the TFT displays "DID NOT TRAIN"
repeat from second step.
• At the garage door opener motor (in
the garage), locate the "LEARN" or
"TRAINING" button. This can usually
be found where the hanging
antenna wire is attached to the
garage door opener/device motor.
Firmly press and release the
"LEARN" or "TRAINING" button. On
some garage door openers/devices
there may be a light that blinks
when the garage door opener/device
is in the LEARN/TRAIN mode.
NOTE:
• You have 30 seconds in which to
initiate the next step after the
LEARN button has been pressed.
• Return to the vehicle and press the
®
programmed HomeLink
Understanding the Vehicle
twice (holding the button for two
seconds each time). The instrument
cluster will display "CHANNEL #
TRANSMIT". If the garage door
opener/device activates,
programming is complete.
NOTE:
• If the garage door opener/device
does not activate, press the button a
third time (for two seconds) to
complete the training.
• To program the remaining two
®
HomeLink
step for each remaining button. DO
NOT erase the channels.
A - Reprogramming a Single
HomeLink
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to the RUN
position.
• Press and hold the desired
®
HomeLink
instrument cluster displays
"CHANNEL # TRAINING" Do not
release the button.
• Without releasing the button
proceed with "Programming a
rolling code" from second step and
follow all remaining steps.
button
buttons, repeat each
®
Button
button until the
3
123